Related Manuals for Victron energy PPP-8
Summary of Contents for Victron energy PPP-8
- Page 1 Manual Peak Power Pack PPP-8: 12,8V / 8 Ah – 102 Wh PPP-20: 12,8V / 20 Ah – 256 Wh PPP-30: 12,8V / 30 Ah – 384 Wh PPP-40: 12,8V / 40 Ah – 512 Wh...
-
Page 2: General Description
1. General Description A Li-ion battery pack with intrinsically safe LiFePO4 cells, a built-in charger and outstanding peak output power performance. Nominal voltage: 12,8 V Battery capacity range: 8 Ah to 40 Ah Low weight and easy to install Ideally suited for mobile applications Thoroughly protected against misuse - Excellent performance in solar and other applications where frequent deep discharge and insufficient recharge would... - Page 3 Fast charging possible through input 1 (high current output) - A battery charger or inverter/charger can be connected to the high power output for fast charging. The maximum charge current is 40 A and the absolute maximum voltage is 14 V (a higher charge voltage may damage the Li-ion cells in case of cell charge unbalance).
-
Page 4: Safety Instructions
2. Safety instructions Danger of explosion from sparking • Please read this manual carefully before the product is installed and put into use. • This product is designed and tested in accordance with international standards. The equipment should be used for the designated application only. -
Page 5: Battery Care
3. Battery care • The PPP must be fully charged before first use. A full charge is indicated by the blue LED lighting continuously • When not in use, the PPP must be switched to storage mode and fully charged at least every 12 months •... - Page 6 Connection of the high current output to a caravan mover The mover control box can be connected directly to the “mover” output of the PPP. The cable ends must be stripped for 15 mm. Carefully insert all wire strands into the connectors and tighten the screws.
- Page 7 Connection of the power adapter (mains) The “mains” jack connects to the 15 V power adapter (included). The power adapter has to be connected to a mains outlet socket. (100…240 VAC, 50…60 Hz) The car/solar input A 11 to 25 VDC power source can be connected to the car/solar input, to charge the PPP from the towing car electrical circuit, a 12V-solar panel or a 12V-battery.
- Page 8 Cable size Name Color Left Turn Signal Yellow Rear fog lamps Blue Ground(-) for pin 1 - 8 White Right Turn Signal Green Tail, side, registration Brown Stop lamps Tail, side, registration Black Reversing lamps Pink +12 V permanent Orange +12 V via ignition lock Grey Ground (-) for pin 10...
-
Page 9: Operation
5. Operation Push button: • Press shortly: The high power output will be on during 30 min., LED lights red. The domestic output will be on permanently (domestic output not available on 8 Ah model). • Press during 2s: Both the high power output and the domestic output will be permanently on. -
Page 10: Solving Problems
6. Solving problems Failure Possible Remedy description Cause No power Battery Charge discharged No power, LED Output Check wiring flashing RED shorted No power, LED Over Cool down flashing RED temperature Power output Overload Use correct tire pressure switches off and roller engagement repeatedly when force. - Page 11 We obviously recommend the "future" Victron Energy Peak Power Pack user to carefully read the manual so as to make optimal use of the Victron Energy PPP. The following FAQ list is to be used as a supplement to the manual.
- Page 12 current output. Max charge voltage: 14,0 V. See datasheet for max. charge current. Is the PPP No, it is charged to 60 %...80 %. already fully charged at the time of purchase? How many Any 110…230 V camping site Amperes are at connection will do.
- Page 13 temperature on performance is best around lifetime and 25…35 degrees Celsius. performance? Freezing temperatures adversely affect maximum current output of any battery. What if I No dangerous situation will occur, accidentally drop but correct operation can no the PPP? longer be guaranteed. III.
- Page 14 available usage time? Can the PPP be Yes. Use the “domestic” output to used in power the system. Disconnect the combination with system after use to prevent a 12 V fully unnecessary discharge. automatic satellite installation? Does the nose Yes, the more weight on the wheel weight shaft/nose wheel, the deeper it have any...
- Page 15 planes. Please ensure large diameter cables are used. If cables with insufficient cross section are used, the current from the PPP may cause the wires to glow or catch fire. Are there any The lithium iron phosphate cells similarities with in the PPP have no "thermal run mobile phone, away"...
- Page 16 PPP be horizontally on the bottom of the installed? caravan. Is the length of Yes. They need to be as short as the cables possible (max. 1 m); diameter between the PPP between 10 and 16 mm2. A main and the Mover power switch is allowed but not electronics required.
- Page 17 Peak Power Pack PPP-8 PPP-20 PPP-30 PPP-40 Capacity 8 Ah 20 Ah 30 Ah 40 Ah Stored energy 102 Wh 256 Wh 384 Wh 512 Wh Battery type Lithium-ion ( LiFePO4) Nominal voltage 12,8 V No load battery drain when on <13 Ah / year (<...
- Page 18 Serial number: Version : 05 Date : July 7 , 2020 Victron Energy B.V. De Paal 35 | 1351 JG Almere PO Box 50016 | 1305 AA Almere | The Netherlands General phone : +31 (0)36 535 97 00 E-mail : sales@victronenergy.com...
Need help?
Do you have a question about the PPP-8 and is the answer not in the manual?
Questions and answers