Camlink CL-AC21 - Camera Manual

Table of Contents

Contents

1 Description
2 Installation
3 Downloading and installing the app
4 Safety
5 Cleaning and maintenance
6 Documents / Resources
- 6.1 Download manual

Description

(fig. A)
Description

1. On/off button Mode button	Press and hold the button for 3 to 5 seconds to switch on or off the device. Note: The device switches off automatically when the preset idle time has been reached or the battery is low. Press the button to select the required mode.
2. Shutter OK button	Photo mode / Photo burst mode / Time lapse mode: Press the button to take a photo. Press and hold the button for 3 seconds to enter or exit the quick-mode menu. Video mode: Press the button to start and stop recording video. Press and hold the button for 3 seconds to enter or exit the quick-mode menu. Press and hold the button to enter Wi-Fi mode. Playback mode: Press the button to play back photos and videos. Menu mode: Press the button to confirm the selection. Car DVR mode: Connect the device to the cigarette lighter connection in your vehicle and use it to record continuously.
3. Playback button Up button Wi-Fi button	Playback mode: Press the button to move up in the menu.
4. Down button	Video mode / Photo mode / Playback mode: Press the button to move down in the menu.
5. Charging indicator	The indicator flashes red when the device is being charged. The charging indicator lights red continuously when the device is fully charged.
6. Display
7. Lens
8. Microphone
9. Speaker
10. Memory card slot (microSD / TransFlash)	Insert a memory card into the memory card slot (storage).
11. USB port (Micro USB)	Use the USB port and the USB cable to connect the device to the computer (charging / data transfer) or the cigarette lighter connection of your vehicle (charging). Note: For charging, make sure that the device is switched off. For data transfer, make sure that the device is switched on.
12. USB cable
13. HDMI input (Micro HDMI)	Connect a TV to the HDMI input using an HDMI cable.
14. Battery compartment	Open the battery compartment. Insert the battery into the battery compartment. Close the battery compartment.

Installation

(fig. B)
Installation

Refer to the illustration to install the device.

Downloading and installing the app

The "iSmart DV" app allows you to control the camera remotely using a smartphone or a tablet.

Download and install the app from the app store on your mobile device by searching the keywords "iSmart DV."
Switch on the device.
Enable Wi-Fi.
Search for "CL-AC21" on your mobile device.
Select "CL-AC21". Enter the password: "1234567890".
Open iSmart DV app.

Safety

RISK OF ELECTRIC SHOK
DO NOT OPEN

To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
Disconnect the product from the mains and other equipment if a problem should occur.
Read the manual carefully before use. Keep the manual for future reference.
Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
Do not expose the device to water or moisture.

Cleaning and maintenance

Do not use cleaning solvents or abrasives.
Do not clean the inside of the device.
Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
Clean the outside of the device using a soft, damp cloth.