Contour Falcon 30 Fitting Instructions

built-in independence
Fitting Instructions
Falcon 30 Shower Tray
- Falcon 30 is a fully customisable
tray, that can be cut to almost any
specific length.
- An end cap is provided if you are
cutting a tray tdown by up to
300mm.
- See the table below to see how best
to achieve common non-standard
tray sizes.
- Falcon 30 trays are not handed.
Tray Standard Length Standard Width
FALC30-900x900
FALC30-1000x1000
FALC30-1300x700
FALC30-1400x800
FALC30-1500x700
FALC30-1800x700
FALC30-1800x800
showers with an
output of UP TO
Contour Showers, Siddorn Street, Winsford, Cheshire CW7 2BA
Telephone: 01606 592586 Fax: 01606 861260
Email: sales@contour-showers.co.uk Website: www.contour-showers.co.uk
900mm 900mm
1000mm 1000mm
1300mm 700mm
1400mm 800mm
1500mm 700mm
1800mm 700mm
1800mm 800mm
SUITABLE for
15 litres per
minute
Cut Down To Cut Down To
- -
- -
1200x700mm -
1300x800mm 1200x800
1400x700mm -
1700x700mm -
1700x800mm
IMPORTANT to
protect the shower tray
from being marked
whilst being installed,
please cover with a
cardboard covering
ST90CPB-P-70 Gravity Waste
•Standard trap with 50mm water seal for use with a shower tray
with a 90mm diameter waste.
•Only 70mm in depth.
•110mm Chrome plated, brass flange and petal grid fitting.
•Flow rate approximately 35 litres per minute.
•1 ½" multi fit outlet, which can be swivelled to any desired angle.
•Simple to install.
ISSUE 3
Contour Showers, Siddorn Street,
Winsford, Cheshire CW7 2BA
18
CS-CPR-14527-14
FALC30_40
PH
EN 14527:2016
CL 2
Cut Down To
Falcon 30 trays can be
-
pre-cut to a standard or
bespoke length at the
-
factory FREE OF CHARGE
-
when instructed at the time
1100x800mm
of placing an order.
-
-
assistance with your
installation or any other
technical help please
call: 0845 402 9924
built-in independence
For technical