AEG TR708L2OZ User Manual page 17

its symbol appears on the display or the
led above the corresponding button lights
up.
8.6 Child lock option
The child lock can be set to prevent
children from playing with the appliance.
The child lock option locks all touch
buttons and the program dial (this option
does not lock the On/Off button).
You can activate the child lock option:
• before you touch the Inicio/Pausa
button - the appliance cannot start
• after you touch the Inicio/Pausa
button - programs and option
selection is unavailable.
Child lock option activation:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down Alarm button
by around 3 seconds.
The symbol appears on the display.
4. To deactivate the child lock, touch
the above button again until the
symbol disappears.
8.7 Starting a program
To start the program:
Touch the Inicio/Pausa button.
The appliance starts and the LED above
the button stops flashing and stays on.
8.8 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn
on the appliance.
3. Set a new program.
8.9 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Alarm.
option is activated, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
symbol signals the
execution of the anti-crease
phase. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds
to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
ENGLISH 17
Adjustment of