Table of Contents
Advertisement
Quick Links
We thank you for your purchase, and please contact us for any assistance that you may require. You have just purchased one of the
best Motorcycle LED multicolor kits in the industry. Follow these instructions and you will be proud of the end results.
What's in the box?
(4) 36-LED strips w/ 6" connector wire on both ends
(14) 9-LED strips w/ 6" connector wire
(2) 9-LED strips w/ 72" connector wire
(4) 1 to 5 connectors
(9) 1 to 2 Y connectors
(9) M to F 18" extensions
(9) M to F 36" extensions
(1) 16 Function Wireless Remote Control Module w/ (2) Key FOBs
In-Line fuse, zip ties, alcohol pads, silicone sealant, 3M Adhesion Promoter
Let's get started....
1. Never work on your bike when it's hot! Make sure your bike is cool and parked on a flat surface.
2. Locate your battery. Remove your seat and disconnect the negative (-) cable of your battery to avoid safety hazards. Make sure
the negative cable does not touch or contact the positive (+) terminal of the battery.
WARNING
DO NOT ALLOW an exposed negative wire to touch the metal frame of your bike. This will create a negative short circuit. If this
happens, the lights will illuminate very dim, and you can't turn the lights off. This is not a malfunction of the remote-control box.
Locate and repair the negative short circuit and your lights will work as described. If you cut any strips, you must seal the cut
end with silicone sealant or you will have a negative short circuit.
DO NOT mount the LED strips to any component of the motorcycle that produces heat or is part of the system at engine
temperature. DO NOT mount directly on the engine, oil tank, oil lines, coolant system, etc.
855.969.2453
288-LED MULTICOLOR KIT INSTALLATION GUIDE
www.rushbikes.com
Rev. A
Advertisement
Table of Contents
Summary of Contents for Rush 288-LED
- Page 1 288-LED MULTICOLOR KIT INSTALLATION GUIDE We thank you for your purchase, and please contact us for any assistance that you may require. You have just purchased one of the best Motorcycle LED multicolor kits in the industry. Follow these instructions and you will be proud of the end results.
- Page 2 You may cut the strip if you wish one time only in a multiple of 3 LEDs. Please cut the strip within the copper as per below. Note: Do not cut strip while connected to power source. Do not let end of cut strip touch frame of bike. Seal the cut end of the strip with the supplied silicone sealant.
- Page 3 The promoter used will cause immediate and permanent adhesion on contact with the 3M tape so be sure to TAKE YOUR TIME. You must get it right the first time for a guaranteed trouble-free installation. For best results, attach your lights within one hour or less after the promoter has been applied. Install the Front &...
- Page 4 WARRANTY INFORMATION The Rush Lights original-owner warranty is only available to customers who purchase genuine Rush Lights products from www.rushbikes.com, ordering over the phone, or by purchasing in person at the shop. This warranty is null and void in the absence of an original sales receipt from one of the purchasing options.
- Page 5 KIND WHATSOEVER, REGARDLESS OF THE LEGAL THEORY AND WHETHER ARISING IN TORT OR CONTRACT, SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT FOR WHICH SUCH CLAIM IS MADE. IN NO EVENT SHALL RUSH LIGHTS BE LIABLE TO PURCHASER FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO, COMPENSATION, REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER.
Need help?
Do you have a question about the 288-LED and is the answer not in the manual?
Questions and answers