Assembly & Installation; Unpacking Your Freezer; Adjusting Your Freezer; Proper Air Circulation - NewAir NFT050GA00 Owner's Manual

ASSEMBLY & INSTALLATION

UNPACKING YOUR FREEZER

•
Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
•
Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.

ADJUSTING YOUR FREEZER

•
Your freezer is designed for freestanding installation only. It should not be
recessed or built-in.
•
Place the freezer on a floor strong enough to support it fully loaded.
•
When moving the freezer, never tilt it more than a 45 degree angle. This
could damage the compressor and the sealed system.
•
If the freezer is tilted let it stand in an upright position for at least 24 hours
prior to plugging. This is to allow the refrigerant to settle.

PROPER AIR CIRCULATION

•
To assure your freezer works at the maximum efficiency it was designed
for, you should Install it in a location where there is proper air circulation,
plumbing and electrical connections.
•
The following are recommended clearances around the freezer:
•
Sides 4" (102mm)
•
Back 4" (102mm)
•
Top Do not block
www.newair.com
EN
12