BrookVent AirVent SM Ultima Installation & Operation Manual

Installation & Operation Guide
External Hood
Internal Vent
FITTING THE INTERNAL VENT (See Table 1):
1. Place the vent over the slot and line up with the pre-
drilled screw holes.
2. Screw the vent to the frame (c/w screw cover caps).
Care should be taken not to over tighten the screws.
FITTING THE EXTERNAL HOOD (See Table 1):
1. Remove end caps by pushing a narrow screw
driver/tool through the external hood's underside
opening. (See diagram below).
2. Place the hood over the slot and line up with the pre-
drilled holes.
3. Screw the hood to the frame (care should be taken not
to over tighten the screws).
4. Replace the push-fit end-caps.
INSTALLATION DIMENSIONS:
Table 1
O/A Slot
Equivalent Area
Height
(sq.mm)
(mm)
2960
5000
V1 22.07.20 UK
O/A Slot
Length
(mm)
10 300
10 530
INSTALLATION INSTRUCTIONS:
1. Prepare the slots and pre drill the holes
as per Table 1 (overleaf) avoiding glazing
rebates.
2. For added weather performance, silicon
sealant should be used at the top of the
external hood where is meets the frame.
3. Screws should be Pan-head screws (e.g.
No.6 x 5/8 self-tap Pan Pozi S/S A2). Do
not use Countersunk screws.
4. The screw should be suitable for the
material it is being used in.
O/A Vent Vent Hole
Length Centres
(mm) (mm)
360 348
570 558
CROSS SECTION [mm]:
DIMENSIONS
PVC Frame
O/A Hood Hood Hole
Length Centre
(mm) (mm)
424 412
584 572
brookvent.co.uk