Table of Contents
Advertisement
IR Sensor Activation
The scanning process is initiated by an infrared (IR) device that is below the
output window. The signal extends approximately eight (8) inches beyond the
output window in long range mode and in short rang mode, it extends
approximately three (3) inches (Refer to Figure 6). The IR device remains
active as long as power is applied to the unit.
When the unit remains dormant for a time, the laser will turn off. In this stage,
the scanner's computer is on "standby". To reactivate the unit, wave an object
in front of the IR sensor or pick up the scanner and direct the output window
downwards.
Figure 6
23
Advertisement
Table of Contents
