Advertisement
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
•
Certain works and activities must not be performed with this crane trolley, for they might cause
material damages and personal injuries.
•
It is forbidden to transport persons with this crane trolley.
•
Do not transport charges loads over persons' heads.
•
Load may only be lifted vertically. It is forbidden to pull loads transversally.
•
Do not tear stuck or jammed loads off the crane trolley.
•
Do not leave loads lifted unattended.
•
Do not touch moving parts.
•
It is forbidden to use the crane trolley for tearing, detaching, or lateral pulling.
•
The maximum capacity must not be exceeded.
•
Check the crane trolley for damages before using it. Do not use a damaged crane trolley, but
have it repaired by qualified persons before using it again.
•
Before every use, check the crane trolley for correct assembly.
•
Before every use, check the rollers. Especially look for the lateral play between the rail support
and rollers.
•
Before every use, check the screws and crossbars for stability.
•
Before beginning to work, persons using this crane trolley must read the manual (especially the
safety instructions) or be informed about its content.
•
Do not wear loose hair, clothing, or jewellery. Stuck in moving parts, they might cause injuries.
•
You must not remove or obliterate plates or stickers that contain safety instructions and warn-
ings. All safety instructions and warnings attached to the crane trolley must be kept complete
and readable.
•
Important!
Being designed for manual use, the crane trolley must not be operated with the help
of a motor, e.g., the gear must not be driven by a power drill.
Working principle
The crane trolley is operated by pushing forward the load moving on the lower flange of the rail and the
rotatable support pin. Thus, the crane trolley, that must be fixed with a manual block, becomes a flat
conveyor.
Assembly
Assemble the crane trolley as follows:
•
Measure the real width of the rail support.
•
Evenly fix the necessary number of spacer washers to the internal side of the lateral gear plate
so that the roller flanges of the rotatable gear bolts are 6 mm larger than the gear supports
themselves.
•
Suspend the maximum safe load to the gear and slowly move the device on the entire length of
the rail to check its operability.
•
Note that the maximum charge capacity depends on the model.
https://www.XPOtool.com
The Tool Experts
Item 62596–62598
Page 3
05 2022-1
Advertisement
