Hasbro Playskool Play Favorites Step Start Walk 'n Ride Manual

Hasbro Playskool Play Favorites Step Start Walk 'n Ride Manual

Advertisement

Quick Links

Product must be assembled by an adult. This product contains
small parts which are necessary for assembly. Prior to and
during of this product, keep small parts out of children's reach.
Small parts pose a choke hazard to children under 3 years.
MAXIMUM WEIGHT 42 LBS. (19 KGS.)
Adult assembly required.
Phillips/cross head screwdriver
(not included) needed for assembly
Thank you for choosing this
PLAYSKOOL toy!
Step Start Walk 'n Ride
INCLUDES: body/chassis, 4 wheels, front handle, rear handle, handle retainer, domed lid,
Dial, roller, spinner (2 pieces), antenna, gear shift, 4 plain #6 screws, and 1 #6 screw with attached washer.
CHASSIS
1

ATTACH WHEELS:

Tip body/chassis on its side. Snap wheel onto axle,
with flat side of wheel against chassis. Repeat for
remaining 3 wheels.
.
TM
WHEEL
TO AVOID SERIOUS INJURY: Continuous adult supervision
required; never use near motor vehicles, near streets,
swimming pools, hills, steps, or sloped driveways. Always
wear shoes. Allow only one rider.
REAR HANDLE
FRONT HANDLE
2

ASSEMBLE HANDLES:

To snap front and rear handles together:
Place rear handle upside down on flat surface.
Holding front handle with back facing rear handle
and perpendicular to rear handle, snap posts on
front handle into holes in rear handle.
05545
OVER
9
months

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Playskool Play Favorites Step Start Walk 'n Ride and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hasbro Playskool Play Favorites Step Start Walk 'n Ride

  • Page 1 05545 OVER Product must be assembled by an adult. This product contains TO AVOID SERIOUS INJURY: Continuous adult supervision small parts which are necessary for assembly. Prior to and required; never use near motor vehicles, near streets, months during of this product, keep small parts out of children’s reach. swimming pools, hills, steps, or sloped driveways.
  • Page 2 FRONT HANDLE CARDBOARD INSERT SLOT BODY ATTACH HANDLE ASSEMBLY TO BODY: Turn body/chassis on its side. Insert front handle through slot in body. Lift body and remove cardboard insert. RIDGES Fit axle on rear handle into ridges in underside of body. AXLE Place handle retainer over axle (retainer fits only one way).
  • Page 3 ANTENNA DOMED LID HOLE RECESSED AREA ANTENNA: DOMED LID: Antenna fits only one way. Insert end of Insert posts on domed lid into holes in antenna into hole. recessed area. SPINNER PIECE GEAR SHIFT SPINNER RECESSED AREA RECESSED AREA SPINNER: GEAR SHIFT: Slide slots on each spinner piece into each other Gear shift fits only one way.
  • Page 4 Rotate handles up then lower body onto chassis. locks Make sure the handle into place. Product and colors may vary. © 2012 Hasbro. All Rights Reserved. TM & ® denote U.S. Trademarks. U.S. Pat. Nos. 6296268 and D424126. 05545 PN 7268760000...

This manual is also suitable for:

05545

Table of Contents