Remote Control; First Installation - Tele System TS SMV13 Quick Start Manual

Product description
Connections
The following inputs and outputs are available behind the TV:
1. USB 2.0 (x2): USB2.0 ports for Mediaplayer function
2. Headphone output: 3.5mm jack.
3. CI/CI: CI/CI Common Interface module slot.
4. Audio Out: Digital audio output.
5. HDMI1, HDMI2, HDMI3 (v.1.4): to connect an AV source.
6. RF IN (T2/C): Antenna input (IEC) for terrestrial (DVB-T/T2) or cable (DVB-C).
7. RF IN (S2): Satellite RF Antenna Input (type F).
8. RCA: Audio-video input for connection of RCA devices (CVBS - Stereo LR).
9. LAN: Ethernet port (RJ45) required for SmartTV/HbbTV functions.
10. Power (230VAC, 50Hz)

Remote Control

Place 2 AAA batteries (not supplied) in the remote control compartment respecting the
correct polarities. Exhausted batteries must be disposed of separately from household
waste and bring to any point of sale or collection.
WARNINGS
To prevent corrosive liquid leakage from damaging the remote control, it is advisable to
remove the batteries if you believe you will not use the device for a long time.
Avoid using different types of batteries such as new and used batteries at the same time.

First installation

Connect the antenna cable (terrestrial and/or satellite) and the ethernet cable (if available).
After turning on the TV, perform the first installation as from wizard, use the arrows and OK
keys to select and confirm:
Step 1. Select the OSD Language;
Step 2. Connecting to the network (cable or wireless)';
a. Cable: the connection to the network is established without any kind of
intervention;
b. Wireless: Select use WiFi, then choose the WiFi network you want to connect to
the TV and enter the password (press OK to invoke virtual keyboard), confirm
selecting Connect;
Step 3. Select the Country;
Step 4, 5. Terms of service and Conditions (it is possible to skip those steps, but some
functionalities could be not available);
Step 6. Select the operative mode. In case of TV selection, TV will ask to set the channel
scanning;
Step 7. Set and confirm PIN (the PIN is requested in some setting submenus);
ENGLISH