Johnson & Johnson LifeScan OneTouch Ultra Procedure Manual

Setting Up the Meter

With the meter off, press and hold M button for three seconds
to enter setting mode.
STEP 1
Set hour and minutes.
With hour flashing, press C button
until correct hour appears on display
and then press M button. Repeat step
with minutes flashing on display.
Set year, month, and day.
After setting time, scroll to year using
M button. With year flashing, scroll to
correct year with C button and press
M button. Repeat step for month and day.
STEP 3
Set unit of measurement.
The mmol/L unit is standard in Canada.
Press M button to turn meter off.

Using the Meter Memory

STEP 1
Enter memory mode.
Start with meter turned off. Press the M button.
When you see 14-day average followed by
30-day average, you are in memory mode.
Recall test results.
The most recent test result with date and time
appears. Press C button once and the next most
recent test result will appear. Continue pressing
C button to recall last 150 test results in order.
Press M button to turn meter off.
Abbreviated
Procedure Guide
Important: Read detailed instructions and other important
information in your OneTouch ® Ultra ®
Test Strip insert before doing a test.
STEP 2
STEP 2
Owner's Booklet and
Coding the Meter
STEP 1
Insert test strip.
The meter turns on automatically.
STEP 3
Find code number.
It is on test strip vial. Press C button
to scroll to same number on display.
It will flash briefly then remain solid.
When appears, start test.
Note: The meter must be
coded for every new vial
of test strips.
Reminder: Contact bars go first. Push
in firmly until it will go no further.
STEP 2
- - -
appears on display.
This means there is no code number
stored in memory.