LV switch IPPBX800 Quick User Manual

LV SWITCH
IPPBX800
Quick User Guide
Items
IPPBX800 host
Power cable
Network cable
Quick user guide
Ear hangings Bracket
For more information,please check the operation manual from the
Vendor or contact the after-sales person from LV switch Inc.
Email:service@lvswitches.com
Call:86-0757-82288116
IPPBX800 Product Introduction
LV Switch IPPBX 800 is the IP voice gateway based on the
applications of offices communications of medium-sized and
small enterprises.LV Switch IPPBX800 supports analog and SIP
trunks,offering
nagvigation,conference bridge etc affairs.The system is based on
the Web management surface which supports remote upgrade,
maintenance and centralized management etc
IPPBX800 Front Panel Overview

IPPBX Front Panel Overview
1 PWR：power status indicator
2 SYS：system status indicator
3 FXO indicators
4 FXS indicators
 IPPBX Back Panel Overview
Quantity
IPPBX Back Panel Overview
1
1 AC power input：AC100～240V 50/60Hz；
1
2 Power switch
1
3 USB 2.0；
1
1WAN+3LAN； Interface type：RJ45；
4
2
10/100/1000Mbps network adaption；
5 1 Console;
6 12*FXS； interface type：RJ11；
7 4*FXO； Interface type：RJ11；
8 Ground column
follow me,multi-level voice
Interface type：RJ45；
Precautions for installation and Use
In the process of installation and operation of the equipment, the
following safety recommendations are put forward：
Avoid shaking. Recommend use of standard cabinet;

Please place the equipment far away from the damp area and

away from the heat source;
Please confirm the correct grounding of the equipment;

Please install the anti-static wrist during the installation &

maintenance of the equipment, and ensure that the anti-static
wrist is in good contact with the skin;

Please do not plug in the device's interface boards and
modules.
Equipment on the shelf
Screw the equipment to the standard
There is a ground yellow terminal behind the device,
symbol expressed. The steps of the ground wire connection are as
follows:
Screw down the nut on the ground terminal of the chassis.

Put one end of the grounding wire on the grounding post of

the rear panel.Put on and tighten the retaining nut.
Connect the other end of the ground cable to the wiring

terminal.