Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for JCM Technologies HDOORPOSITION
- Page 1 HDOORPOSITION User Manual...
-
Page 2: Table Of Contents
Table of contents Introduction Configuration with cloudAssistant Installation Operational mode Operation with two HDOORPOSITION sensors Operation with one HDOORPOSITION sensor Verification LED behaviour Technical data Battery Batteries replacement Regulatory Data UKCA Declaration of conformity EU Declaration of conformity jcmtechnologies... -
Page 3: Introduction
Check door status with cloudAssistant from anywhere, instantly, with no need for more wires thanks to radio technology. The HDOORPOSITION sensor activates when the magnet is close to it and sends a radio signal to HONOADOOR. Install the magnet on the bottom of the door and the sensor at the same height on the wall to know when the door is completely closed. -
Page 4: Configuration With Cloudassistant
Enter the installation with the HONOADOOR device to which you wish to link the HDOORPOSITION sensor. Go to the "Equipment" tab. Select the equipment where the HONOADOOR is. Complete the sensor fields. Save. Three setting fields must be completed for each sensor: •Radio sensor X name: this is a descriptive field for the sensor. -
Page 5: Installation
LED STATUS lights up once every 15 seconds, close the cover, and mount on the wall. Example installation with 2 HDOORPOSITION sensors and 1 MAGNET: The sensors and magnets must be installed according to the distances and layout shown in the image. -
Page 6: Operational Mode
Operational mode The check door status, selection "Get door status" (button with the door). Operation with two HDOORPOSITION sensors DOOR CLOSED DOOR OPENED jcmtechnologies... -
Page 7: Operation With One Hdoorposition Sensor
Operation with one HDOORPOSITION sensor Closing limit switch sensor: DOOR CLOSED DOOR NOT CLOSED jcmtechnologies... - Page 8 Opening limit switch sensor: DOOR OPENED DOOR NOT OPENED The status does not update automatically. Press the "Refresh Status" button to update the door status.. If the HONOADOOR device has been reset (example: due to a voltage drop), the door's status is "Undefined."...
-
Page 9: Verification
Verification Open the HDOORPOSITION sensor cover and press the "TEST" button to check the connection with HONOADOOR. The "ST", "NW," and "IN" LEDs of HONOADOOR blink for 3 seconds. The next 25 times that the HDOORPOSTION is activated, the HONOADOOR LEDs will blink for 3 seconds. -
Page 10: Technical Data
Regulatory Data UKCA Declaration of conformity The manufacturer JCM TECHNOLOGIES, S.A. declares that the product HDOORPOSITION complies with the relevant fun- damental requirements of the Radio Equipment Regulations 2017 and of the RoHS Regulations 2012. EU Declaration of conformity The manufacturer JCM TECHNOLOGIES, S.A.