Table of Contents
Advertisement
Fault
The programme does
not start.
The door cannot
be opened.
The water is not drain-
ing.
Cause and troubleshooting
→ "Deactivating the childproof lock", Page 38
▶
Ready In is activated.
Check whether
▶
→ "Buttons", Page 22
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press
Start / Reload to start the programme.
4.
– –– is activated.
Continue the programme by selecting
▶
and pressing
Drain
→ "Resuming the programme when the programme
status is Rinse Hold", Page 37
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 37
▶
Water level is too high.
Start the Drain
▶
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 55
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 42
▶
– –– is activated.
Continue the programme by selecting
▶
and pressing
Drain
→ "Resuming the programme when the programme
status is Rinse Hold", Page 37
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Detergent dosage is too high.
Ready In is activated.
Start / Reload.
programme.
Start / Reload.
Troubleshooting en
Spin or
Spin or
49
Advertisement
Table of Contents
