WatchNet ENS-08 POE Connection Manual

110V AC / 240V AC
12 Volts Power
PoE
48 Volts Power
Typical 16 Camera connection
with built-in 8 Port POE NVR & 16 Port Switch
POE Cameras
NOTE:
1. External 12 or 16 Port POE Switch is needed to connect the additional 8 cameras.
(If using regular switch, the cameras must have 12V 1Amp Power Source connected)
2. Launch the Config tool from the software CD and assign IP Address to cameras to suite the
local LAN configuration.
3. Please see hardware manual on the software CD for more instructions.
PoE IP Cameras
LAN Router*
Package Contents:
ENS 16 POE*
NVR (X1)
WatchNET Products are subject to continuous changes and
improvements, information on this document is subjected to
change without prior notice.
2015 WatchNET Inc. © All Rights Reserved
Speaker*
Microphone*
Smart Phone*
USB Mouse
LAN / WAN
Free DDNS
www.dvrid.com
IE / Client for Windows or MAC Client for OSX
Cameras (X4 or x8) Remote Control (x1) Software CD (X1)
NOTE:
Cameras included only
in KIT Models and may vary from
KIT Model numbers
QUICK CONNECTION GUIDE
Connecting Your ENS-08 POE
Strobe lamp*
Power
ON/OFF
* Not included/sold separately.
Mouse (X1) Power Adaptor (X2)
Quick Start Guide (X2) Mouse Pad (X1)
720P/1080P VGA*
Simultaneous Display
720P/1080P HDMI*
Simultaneous Display
Ethernet Cable (X1) Power Cable (X2)