Advertisement
How to Use (cont.)
9. The following items are not suitable for the dishwasher:
• Items with wooden, horn china or mother-of-pearl handles
• Wooden items
• Plastic items that are not marked as dishwasher safe
• Items with glued parts that are not temperature resistant
• Bonded items
• Pewter or copper items
• Crystal glasses or stemware
• Steel or cast iron items subject to rusting
• Very small items that may fall through the rack or flatware basket
• Items made from synthetic fibers
• Silver and aluminum
·
• Delicate glazed items
ADD DETERGENT AND RINSE AID
1. Detergent and/or rinse aid must be added before starting a wash cycle. This
dishwasher uses less detergent and rinse aid than a conventional dishwasher.
Generally, only 1 Tbsp. of detergent is needed for a normal wash load.
2. Use only detergent and rinse aid designed for an automatic dishwasher:
• DO NOT use hand soap, laundry detergent, or any other washing
detergent in the dishwasher.
• Store detergent in a dry area.
• DO NOT put powder detergent into the dispenser until you are ready to
operate the washer.
• The hardness of your water will affect the amount of detergent needed.
With hard water, extra detergent is needed to remove deposits left by
excessive minerals. Soft water requires less detergent. Too much
detergent with soft water can cause cloudiness of glassware.
• If using a detergent tablet, select a long program (heavy or normal) to
ensure the tablet has enough time to completely dissolve. Different
brands will dissolve at different speeds.
main detergent
chamber
10
10
tablet or pre-
wash detergent
rinse aid
chamber
indicator
rinse aid
chamber
(continued on next page)
Wards.com
Wards.com
How to Use (cont.)
WARNING:
Keep detergents and rinse aids out of the reach of children and
avoid contact with skin and eyes.
3. After filling, close the detergent dispenser lid and press until it locks in place.
4. Turn the rinse aid cap counterclockwise. Lift and remove cap.
5. The rinse aid dispenser has four settings. It is recommended to
start with the dispenser set at 3. If spots or poor drying occurs,
increase the setting to 4. If there are sticky white stains on
dishes or blue film on glassware, reduce the setting to 2 or 1.
6. Add rinse aid until the indicator window turns completely black.
DO NOT overfill. Use only rinse aid in this chamber. DO NOT use detergent or
other substances.
7. To close, replace the cap and turn clockwise.
8. Wipe up any spilled rinse aid to avoid excessive foaming during the wash cycle.
START THE DISHWASHER
1.
Ensure the dishwasher is level.
2. Ensure water is connected. Turn water on (at the faucet) to full pressure.
3. Check for leaks at the drain and inlet ports.
4. Plug the power cord into an outlet.
5. Close the door and press POWER.
6. Check for kinks in the drain and inlet hoses.
START A WASH CYCLE
1. Press PROGRAM to select desired wash cycle (see page 12).
2. To delay start time, press DELAY (2, 4, 6 or 8 hours).
3. Press START/PAUSE to begin the wash cycle.
4. Press START/PAUSE during a wash cycle to pause operation. During pause, the
Wards.com
unit will beep once each minute until START/PAUSE is pressed again to resume
operation.
5. Press POWER to cancel a wash cycle.
1
888
557
3848
•
•
•
lever
11
11
Advertisement
