Table of Contents
Advertisement
Quick Links
MTX-A Temperature Gauge
1.
Installation ................................................................................................ 2
1.1
Gauge Mounting .............................................................................. 2
1.2
Temperature Sensor Mounting ........................................................ 2
1.2.1
Changing the MTX-A's Gauge Bezel .......................................... 2
1.3
Main Gauge Wiring .......................................................................... 3
1.3.1
Single Innovate Device Relay Wiring Instructions ....................... 4
1.4
Temperature Sensor Wiring ............................................................ 4
2
Download the Logworks 3 software package .......................................... 4
2.1
Installing software ............................................................................ 4
2.2
Connecting to LM Programmer ....................................................... 5
2.3
Temperature Alarm ......................................................................... 6
2.3.1
Updating the Firmware ................................................................ 6
2.4
Logging data from your MTX-A with LogWorks .............................. 7
2.4.1
Adding and Logging MTS channels ............................................ 7
Appendix A: Limited Warranty ......................................................................... 8
User Manual
11-0152
Advertisement
Table of Contents
Related Manuals for Innovate Motorsports MTX-A
Summary of Contents for Innovate Motorsports MTX-A
- Page 1 Temperature Alarm ................. 6 2.3.1 Updating the Firmware ..............6 Logging data from your MTX-A with LogWorks ......7 2.4.1 Adding and Logging MTS channels ..........7 Appendix A: Limited Warranty ................. 8...
- Page 2 The MTX-A gauge is splash resistant (not water proof) and can be mounted so that it is exposed to the outdoor elements. The MTX-A should not be submerged and special consideration should be taken to protect the gauge from direct water spray (water coming from a pressurized source.) When replacing the bezel and/or gauge face verify that the o-ring is properly seated.
- Page 3 (-) post. If other Innovate Motorsports devices are going to be daisy-chained along with the MTX-A, it is recommended that all devices be connected to a single ground point, ideally the battery ground (-) post.
- Page 4 1.3.1 Single Innovate Device Relay Wiring Instructions Temperature Sensor Wiring Fish the Water temp sensor’s two pin connector through the firewall and to the MTX Water Temp/ Volt Gauge. Connect the sensor’s male two pin connector to the female two pin connector on the gauge.
- Page 5 LM Programmer is used to update firmware, change fuel types, and program the two analog outputs. 1. Connect the OUT port of the MTX-A to the provided serial programming cable. Connect the other end of the serial programming cable to your computer. If your computer does not...
- Page 6 1. Connect the MTX-A to the computer and launch LM Programmer. 2. Once connected, LM Programmer will display the current version of the firmware that is installed in the MTX-A. Do not update the firmware if the versions are the same. A firmware update should...
- Page 7 5. The software will now prompt you to confirm that you wish to overwrite the firmware currently on your MTX-A. 6. Click OK, DO NOT power off or disconnect the MTX-A from the computer until the firmware progress screen completely disappears.
- Page 8 Appendix A: Limited Warranty LIMITED WARRANTY Innovate stands behind the quality of its products. Innovate makes the following warranty to purchasers of its products: All new Innovate products carry a one year warranty from the date of purchase. If proof of purchase cannot be provided, warranty will be determined by date of manufacture.
Need help?
Do you have a question about the MTX-A and is the answer not in the manual?
Questions and answers