Precautions For Installation - Panasonic WV-LW2200 Operating Instructions Manual

Precautions for installation

Installation work shall be performed in accordance with
the technology standard of the electric installation.
Grounding
A grounding connection must be made before connecting
the power plug of this product to the main power supply. If a
grounded outlet is used, check the ground resistance (100
Ω or less).
Power supply
Be sure to connect to ground prior to connection of the
power plug to the main power supply. For disconnection
from ground, be sure to disconnect the power plug from the
main power supply first. Be sure to connect the power cord
via any of the following breaking devices:
(1) Connect the power cord via a power supply control unit.
(2) Install this monitor near an electric outlet, and connect
the power cord via the power plug.
(3) Connect the power cord to the breaker with contact gap
of 3.0 mm or more of a distribution board. The breaker
should be designed to break the current flows to and
from all the electrodes connected to the main power
supply except the ground protective conductor.
Installation place
• This monitor is designed to be used indoors. This moni-
tor is not operable outdoors.
• Keep the both side surfaces, top surface and rear sur-
face of this monitor approximately 5 cm away from the
wall.
• Do not mount the monitor on places subject to constant
vibrations. That may cause trouble or damage.
• Do not install this system in any place where it will be
subjected to direct sunlight for a long time or close to
any air conditioning equipment. Failure to observe this
may cause deformation, discoloration, failure, or mal-
function. Please keep this product away from water
droplets or water splashes.
• Avoid the following locations for installation.
• Locations where it may get wet from rain or water
splash
• Locations where a chemical agent is used such as a
swimming pool
• Locations subject to steam and greasy fumes such
as a kitchen and in the special environment of sol-
vents and inflammable gas atmosphere
• Locations where radiation, x-ray, intense radio wave,
or strong magnetism is produced
• Locations on the sea or by the sea, and locations
where a corrosive gas is present
8
Screwing
• The screws must be tightened with an appropriate tight-
ening torque according to the material and strength of
the installation area.
• Do not use an impact driver. Failure to observe this may
damage the screw.
• When a screw is tightened, make the screw at a right
angle to the surface. After tightening the screws, per-
form visual check to ensure tightening is enough and
there is no backlash.
If this system is not used any more, be sure to dismantle
this system.