Advertisement
Table of Contents
Albi Maxi Angular
DOWNLIGHT
Product code
Installation Manual
Warnings
• The safety and compliance of this fitting are not assured unless the following instructions are adhered to. Please retain these instructions
for future reference.
• Always turn the mains OFF prior to installation. See Picture below.
• The luminaire is EN 60598-1:2015/A1:2018 compliant and Installation must be carried out by a licensed electrician.
• Risk of Electric Shock: Prior to installation or maintenance, disconnect the fitting from power supply and other control wiring. Faulty
cables and wiring need to be replaced by manufacturer only.
• Risk of Burns: When in use, the fitting's surface may reach high temperatures and can cause skin burns. It is recommended to install the
fitting out of reach to avoid any physical contact.
• It is recommended to always wear safety glasses and gloves during installation.
• For safety reasons please keep children away from installation site.
• Please follow below instructions for disposal in accordance with the local E-Waste or WEEE (Waste Electrical and Electronic Equipment):
o Fittings cannot be disposed alongside other household waste.
o Remove the lamp/ battery for decommissioning (if applicable)
o Send them to nearest E-Waste or WEEE collection center.
• For further inquiries, please contact Mondolux at https://www.mondolux.com.au/
MD35AR
*Module Heights
9W - 100mm
15W - 120mm
20W - 135mm
mondolux.com.au
*
Ø75mm
Advertisement
Table of Contents
Related Manuals for MONDOLUX Albi Maxi Angular MD35AR
Summary of Contents for MONDOLUX Albi Maxi Angular MD35AR
- Page 1 • Please follow below instructions for disposal in accordance with the local E-Waste or WEEE (Waste Electrical and Electronic Equipment): o Fittings cannot be disposed alongside other household waste. o Remove the lamp/ battery for decommissioning (if applicable) o Send them to nearest E-Waste or WEEE collection center. • For further inquiries, please contact Mondolux at https://www.mondolux.com.au/...
- Page 2 Do not install any inductive loads such as exhaust fans etc. within the same lighting circuit of the current fitting. Issues caused by such connections will not be covered under our warranty policy. ⚫ If you have any questions about the installation of this product, please contact Mondolux. Installation Steps Ensure the mains power is turned off.
Need help?
Do you have a question about the Albi Maxi Angular MD35AR and is the answer not in the manual?
Questions and answers