Aquael MIDIKANI 800 - Aquarium Filter Manual

INTRODUCTION

We are convinced that you will be satisfied with its operation. We ask you to read the instruction manual carefully before using the product to avoid any potential problems.

PRODUCT DESTINATION AND CHARACTERISTICS

MIDIKANI filters are designed for purifying of aquarium water. They are equipped with an external intake pump allowing for operation even in extremely shallow water.

TECHNICAL SPECIFICATION

PARTS

CONDITIONS OF SAFE USAGE

The devide you purchased was manufactured in conformity with all safety standards currently in force on the area of European Union. For long lasting and safe usage please read the safety conditions below:

• The device can be powered from a power grid of voltage stated on the device.
• MK-800 pump can only be used for pumping liquids of temperature up to 35°C and must not be used with inflammable materials or consumable liquids
• The power cord is non-detachable and cannot be replaced. If the cord is damaged, the device must be discarded.
• The maximum submergence depths is stated in technical specification.
• The device is designed for usage only indoors and accordingly to its destination.
• Prior to placing hand in the water, all of the electric devices present in the tank should be unplugged from power.
• This device can be operated by children who are at least eight years of age, by persons with reduced physical or mental capabilities or persons with no prior experience with the device only under supervision or following aninstruction on the safe operation of the device to ensure that the person is aware of any associated risks. The device is not a child's toy! Do not let children to clean or perform maintenance on the device without supervision.

ASSEMBLY AND START-UP

MIDIKANI filter can be installed in three ways depending on the operation type. It is recommended to install a prefilter in form of a sponge cartridge on the intake strainer (index 101235) (Notice! The prefilter is not included in the set and can be purchased separately):
Fig. 2 – intake pump is installed inside the tank onto its wall and performs the function of a pump supplying the filter with water. That solution is recommended for fish tanks.


Fig. 3 – intake pump is installed outside of the tank lower than the aquarium water level and performs the function of a flow pump. The solution is recommended for standard fish tanks. In that case it is crucial to prime the pump by sucking the water in the intake hose prior to starting the pump.


Fig. 4 – intake pump is installed inside the tank to its bottom and performs the function of a pump supplying the filter with water. That solution is recommended for aquariums with low water level.


Fig. 4a – the way of pipes assembling.


The connection scheme shown in the drawings can only be employed inside the tank. In no case should you mount the pump outside the tank using the new elements, as this may result in the flooding of the premises!

MAINTENANCE

The intake pump requires regular cleaning of the impeller (fig. 5a) in order to remove potential mechanical impurities from the impeller chamber. To perform this action after disconnecting the device from power outlet the pump cover (fig. 5b) should be twisted off with an anticlockwise movement, then the impeller cover should be removed. After removing the impeller, it should be cleaned together with the impeller chamber using a soft brush. In case of the pump operating outside of the tank (fig. 2) as a flow pump it is recommended to regularly maintain the gasket placed under the impeller cover by its thorough cleaning and lubricating with technical vaseline. Filtration cartridges inside of the filter should be regularly washed in water removed from the aquarium (not in tap water!). First cleaning should be performed after 2 months from the first filter start, next in case of such need signalized with noticeable decrease of the device efficiency. In order to ensure optimal filter operation it is recommended to replace the filtration cartridges at least once every 12 months. In case of such need the pump casing can be cleaned of algae or scale depositing on the pump using a soft tissue or sponge.
Filter output regulation is performed by turning the steering unit clockwise (fig. 6) in range from 0 to 90 degrees. Turning the steering unit by full 90 degrees will completely stop the water flow and allows for safe removal of the filter from the casing without the necessity to disconnect the pump from electric outlet (e.g. for cleaning the filter interior).

Notice! In order to ensure long and failure free filter operation it is recommended to replace three gaskets (article no 110611): under the steering unit, under the filter chamber cover and under the cover of the intake pump. In case of such need the impeller of the intake pump can also be replaced (article no 110911).

DISASSEMBLY AND DISPOSAL

It is forbidden to dispose of used electric and electrical equipment in a trash bin. Segregating and proper utilization of this kind of waste leads to conserving the resources of natural environment The user is responsible for delivering the used product to a specialized collection point where it will be accepted free of charge. You can obtain information about such a facility at the local authorities at the product seller.

GUARANTEE CONDITIONS

The manufacturer grants a 24 month guarantee beginning on the date of purchase. The guarantee covers defects arising from manufacturer fault i.e. defective materials or assembly errors. It does not cover damage due to user's fault caused by improper handling of the device or using the device for purposes discordant its destination. Attention: any modification or disassembly attempt exceeding normal usage and maintenance cause the guarantee void.
In case of noticing improper operation of the device send it with filled out warranty card to the manufacturer or distributor address. The conformity of the production date stamped on the product and written in the guarantee card is a prerequisite for accepting the guarantee. The following warranty conditions do not exclude, limit or suspend user's rights derived from discrepancy of the merchandise with the agreement. The guarantee is limited to repair or replacement of the unit only and does not cover consequential loss or damage to animate or inanimate objects.

AQUAEL Sp. z o. o.
16-400 Suwałki, Dubowo II 35, Poland
www.aquael.com, e-mail: service@aquael.com