Panasonic Toughbook CF-W2FWCZZBM Operating Instructions Manual page 49

Starting Up
When resuming from the standby or
hibernation mode, [Enter Password]
does not appear even if a password
has been set in the Setup Utility
When the administrator password is
forgotten
When "Remove disks or other
media. Press any key to restart" (or
a similar message) is displayed
When the previous items are not the
cause
Enter Password
Even after entering the password,
[Type your password] is displayed
again
Even when a password has been set in the [Security] menu of the Setup
Utility, [Enter Password] does not appear when the computer resumes from
the standby or hibernation mode. Use the Windows password as follows:
A Click [start] - [Control Panel] - [User Accounts] and click the
account for which the password will be set.
B Add the check mark for [Prompt for password when computer
resumes from standby] in [Control Panel] - [Performance and
Maintenance] - [Power Options] - [Advanced].
If you have created a password reset disk (
played when you fail to correctly enter the password. Follow the message's
instructions and set the password again by using the password reset disk.
If you have not created a password reset disk, after reinstalling setup Win-
dows and then set the password again.
This means a floppy disk that dose not contain system startup information
has been left in the floppy disk drive. Remove the floppy disk, and press any
key.
This message may appear when certain USB devices are connected.
Remove the USB device, or set [Legacy USB Support] in the [Advanced]
menu of the Setup Utility to [Disable].
If the message still appears even after trying the above measures, this may
be an indication that some type of hard disk failure has occurred. Contact
your technical support office.
Press the F9 key in the Setup Utility. This will restore the Setup Utility's
settings to their default values (except the password settings).
Try removing all peripheral devices.
Check a disk error using the following procedure:
A Display [Local Disk (C:) Properties].
Click [start] - [My Computer], right-click [Local Disk(C:)] and click
[Properties].
B Click [Tools] - [Check Now].
C Click [Start] after selecting required items in [Check disk options].
At startup, hold down the F8 key when [Panasonic] boot screen disap-
*1
pears , and release your finger when the Windows Advanced Option Menu
is displayed. Start the computer in Safe Mode, and confirm the details of
the error.
*1
When [Password on boot] is set to [Enable], [Enter Password] appears after the
[Panasonic] boot screen disappears. Hold down the
password and pressing the
The computer may be in "ten-key" mode.
lights up, press the NumLk key to disable the ten-key mode, and then
If
input ( page 16).
The computer may be in Caps Lock mode.
lights up, press the Caps Lock key to disable the Caps Lock mode,
If
and then input ( page 16).
page 21), a message is dis-
F8
Enter
key.
key soon after inputting the
49