RCN TC 450 MRT Instructions For Use

Instructions for use and product information
for medical devices in accordance with Regulation 2017/745
RCN Medizin- und Rehatechnik GmbH, Hauptstraße 4, D-55471 Sargenroth
Phone +49 (0) 67 61 / 91 97 0, Fax +49 (0) 67 61 / 91 97 70, Email: info@rcn-medizin.de
Transport chair
TC 450 MRT
Content
1 Intended use ..................................................... 1
2 General safety regulations................................ 1
3 Operation and functions ................................... 1
4 Accessories ...................................................... 3
5 Technical data .................................................. 3
6 Labelling ........................................................... 3
7 Cleaning and disinfection ................................. 3
8 Maintenance and inspection ............................. 4
9 Storage, reuse and disposal ............................. 4
10 Warranty / Liability ............................................ 4
1 Intended use
The TC 450 MRT is designed for patient transfer in
the MRI range up to 3 Tesla.
The transport chair may only be used inside
buildings on level floors. The model is not suitable
for climbing steps with. The model is designed for
short-term use. Individual adaptations cannot be
made.
Product life: The expected life of the wheelchair is
10 years. Individual components (e.g. wheels and
pads) may need to be replaced sooner depending
on wear and tear. The service life can be increased
by using spare parts.
2 General safety regulations
Use the product only on flat surfaces indoors. When
using the product as a transfer aid, make sure that
the patient's arms are on the armrests or that the
EN
patient holds them in front of the body. The patient's
back should be on the backrest for a stable sitting
position. The feet must be on the extended footrest.
The model can be permanently loaded with a
temperature between 0 °C and 60 °C. Due to the
properties of plastic, damage may occur if the
product is exposed to temperatures outside this
range. Also, do not expose the product to selective
heat loads such as radiant heaters. Check the
product for damage before each use. If there is
damage, do not use the product until it has been
repaired.
All serious incidents related to this product must be
us (manufacturer) reported to
3 Operation and functions
The transport chair is delivered partially assembled
to reduce shipping costs. Assemble the chair as
follows:
1. put on the backrest
2. Screw in 4 x screw (PH2)
3. put on the back of the cushion
IFU_EN_TC450MRT_V01.docx 1