Download Print this page

Germguardian AC151 Remove & Replace Instructions

MODELS: AC151

FILTER REPLACEMENT

The "Filter Reset" indicator will light when it is time to replace your filter. Depending on usage

and environmental conditions the filter will last approximately 6 months. The inside pleats of the

filter will turn from white to grey when it is dirty and needs replacing. It is important to maintain

and change the filter to continue to optimize the performance of the air purifier.

IMPORTANT: Do NOT wash and re-use the filter. Please contact Customer Service to purchase

a replacement filter or visit guardiantechnologies.com.

REMOVE AND REPLACE FILTER

1. Turn off and unplug the unit

2. Flip the unit to access the bottom panel.

3. Turn the filter cover to the left to open.

4. Lift the filter cover off of the unit.

5. Remove and dispose of dirty filter.

6. Replace new filter and place filter cover back on.

Table of Contents

Do you have a question about the AC151 and is the answer not in the manual?

Page 1 REMOVE AND REPLACE FILTER MODELS: AC151 FILTER REPLACEMENT The “Filter Reset” indicator will light when it is time to replace your filter. Depending on usage and environmental conditions the filter will last approximately 6 months. The inside pleats of the filter will turn from white to grey when it is dirty and needs replacing.
Page 2 8. Reset the filter indicator by holding the filter reset button for 5 seconds. 7. Line up the unlock icon on the bottom cover with the arrow on the edge of the base of the unit. Twist the bottom cover to the right to lock, lining up the lock icon with the arrow on the edge of the base of the unit.
Page 3 C cover. 3. Hold the unit in place with one hand. Locate the bulb and reach into the cylinder. 4. Turn the bulb in a counter-clockwise direction (left) to loosen from the socket. 5. Take new bulb and screw into unit using a clockwise motion. Wipe off fingerprints with a dry cloth. 6.