Subscribe to Our Youtube Channel
Related Manuals for Revolution RLC1
Summary of Contents for Revolution RLC1
- Page 1 RLC1 Digital Lighting Controller Owner's Manual 14 April, 2020 Revolution Microelectronics Co., Ltd Page 1 of 7...
- Page 2 Congratulations on your new all-digital lighting controller! The RLC1 can control up to 512 lights in two zones with up to 256 lights in each zone. The RLC1 can control any Revolution or compatible light such as the Phantom, MaxiBright, etc.
- Page 3 If you get RJ-type cables from a local source, make sure they are straight-through and look like this. RevMicro has the right cables of all sizes should you need them, or http://digikey.com is a good source in the USA. Revolution Microelectronics Co., Ltd Page 3 of 7...
- Page 4 Mounting the Controller The RLC1 is designed to be wall mounted. This is easy to do using its removable back plate, which has four holes that can be used for mounting. The top center hole is a “keyhole” style hole which can be used with a single large screw, so that the plate is hung on the screw head.
- Page 5 That's shown as S/R above. You can also set the Delay function to delay the lights coming back on after a power outage. The RLC1 has an internal clock and starts counting when when the power goes out so a 30 minute on-delay will only have 10 minutes to run if the power comes back on in 20 minutes.
- Page 6 Up/Down to choose. Make sure to press the red Save button to save your changes. LED Default Settings If you've made changes and want to go back to our defaults, here's how the RLC1 is set up from the factory: Factory Preset...
- Page 7 9.Zone B Low-voltage external equipment trigger for Lights On 10.Zone B Low-voltage external equipment trigger for Lights Off 11.Zone B Low-voltage external equipment trigger for over temperature External triggers are two wires, dry contacts, ½ amp maximum. Revolution Microelectronics Co., Ltd Page 7 of 7...
Need help?
Do you have a question about the RLC1 and is the answer not in the manual?
Questions and answers