Installation - Glacier bay HD67295W-6001 Installation And Care Manual

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Ensure the gasket (B) is on the bottom of the
new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Secure the faucet (A) to the sink using the
mounting nuts (C) provided. Hand-tighten only.
NOTE: A silicone is required under the gasket (B).
C
2
A
B
4
Preparing the pop-up assembly
□
Remove the pop-up stopper (D) and drain
ange (E) from the drain body (H).
H
D
E