Lyte 121230 User Manual

Thank you for choosing lyte, please read this product manual carefully before using our products.
Features
1. This is a fully automatic battery charger, designed for RV, camper, boat and other applications.
2. Automatically adjustable three-stage charging program, suitable for lead-acid, AGM, GEL, LiFePO4, Lithium-ion (NCM)
batteries, total 5 types of batteries.
3. An external display and/or Bluetooth module can be connected to the charger, data can be viewed through the mobile
phone app (these accessories need to be purchased separately)
4. If you need to drive a long distance, please charge the battery fully.
5. Exquisite design, small size, light weight, high-frequency switch and buck-boost technology to ensure safe
and reliable operation.
6. Fully automatic operation; when the car alternator starts, the charging function is automatically activated and
avoids starter battery discharge when the alternator is stopped.
7. Unattended charging; the controller will automatically disconnect from the main battery under extreme
conditions, such as overheating, overvoltage, short circuit, over-current.
8. External temperature sensor: 1. The charging voltage can be automatically compensated according to the ambient
temperature (only for lead-acid batteries, lithium batteries have no temperature compensation function); 2. When the
ambient temperature is too low (-20℃) or too high (50℃), the charger will charge at a safe voltage.
Installation
1. Please install the charge controller as close to the main battery as possible, and keep the surroundings clean, tidy and
well ventilated. To be installed on a hard surface.
2. It should be installed in a moisture-proof, water-proof and corrosion-proof place.
3. When the charging controller is working, the fan will bring out heat, so when installing, make sure to leave at least
>10cm behind the charger controller.
4. According to the table below, select the specifications of the connecting wire, the length and the specification
of the fuse. Reverse polarity connection of the battery will cause serious damage to the equipment.
Cable Cross-section
Cable Length "+ IN" to "+ START"
2
6mm
2
10mm
2
16mm
The house/leisure/Board battery type (lead-acid, GEL, AGM, LiFeP04, lithium-ion (NCM)), please set the battery type before use
5
.
up to 3.5m
up to 6m
up to 10m
energy. made easy.
DC-DC Battery charger
User manual
lyte 121230 | lyte 121245
B2B121230
Cable Length "-OUT"
to "- Board"
0.8-2m
1.5-3m
2.5-5m
Cable Length "+OUT" to "+Board"
0.8-2m
1.5-3m
2.5-5m