Page 1
Model 3101RC ADSL2/2+ Triple-Play Access IPDSLAM Module Quick Start Guide Important This is a Class A device and is intended for use in a light industrial environment. It is — not intended nor approved for use in an industrial or residential environment Sales Office: +1 (301) 975-1000...
This section provides safety information to review before installing the Model 3101RC. The information includes required installation tools, safety requirements, and electrostatic discharge protection. 1.1 Tools and Test Equipment Requirements To install and maintain the Model 3101RC, you should have the tools and test equipment listed in table Table 1.
The Model 3101RC supports 24/48 ADSL/2/2+ ports. There are two RJ-21 50-pin female connectors on the front panel of the 3101RC TM card. One connector is for DSL ports 1~24; the other is for DSL ports 25~48. When installing, just plug the end of a cable with the RJ-21 50-pin male connector into the DSL interface female connector on the TM card.
1, 2 T/Rx+, T/Rx - LED B LED A 3, 6 T/Rx+, T/Rx - 4, 5 T/Rx+, T/Rx - Pin 8 Pin 1 7, 8 T/Rx+, T/Rx - Figure 2. Trunk Port RJ-45 pin assignment Model 3101RC Quick Start Guide...
Page 5
2.3 Ethernet Port (10/100 ENET) on Trunk Card The Model 3101RC provides one RJ45 Jack (10/100 ENET) on the front panel of 3101RC card for Ethernet inter- face connection. The detailed pin assignment is shown in figure PIN 1 PIN 8...
Page 6
2.4 Console Port (CONFIG) The Console interface (CONFIG) on the front panel of 3101RC card is the main control interface of the Model 3101RC. The RJ45 connector pin assignment follows the EIA-561 signal type used in RS-232 interface, and the Model 3101 is a DCE Device.
Page 7
Not used Not used Data Set Ready Not used Not used Request To Send Not used Not used Clear To Send Not used Not used Carrier Detect Not used Not used Ring Indicator Not used Model 3101RC Quick Start Guide...
3.0 Additional Information Refer to the Model 3101RC Getting Started Guide located on the CD-ROM shipped with your device and available online at For detailed information about: www.patton.com/manuals. Installing, configuring, operating, and troubleshooting. • Warranty, trademark & compliance • A.0 Customer and Technical Support...
Terminal Equipment and the mutual recognition of their conformity. The safety advice in the documentation accompanying this product shall be obeyed. The conformity to the above directive is indicated by the CE sign on the device. Model 3101RC Quick Start Guide...
Warranty For warranty information, refer to the Model 3101RC Getting Started Guide located on the CD-ROM that came with your device or available online at www.patton.com. In accordance with the requirements of council directive 2002/96/EC on Waste of...