Conair InterPlak DPI8 Instruction Manual

using.
product,
DPI8
®
Using the Interplak
The Fastest and Easiest Way to Brush

6 Simple Steps:

1. Charge the lower battery unit.
IMPORTANT NOTE: The plug blades and face must be clean and dry before
plugging into AC outlet to reduce risk of burns, electrocution, fire or injury.
Allow base to charge for at least 24 hours before first use.
Note: If the outlet is controlled by a wall switch, be sure the switch is always
on for a continuous charge. Plug the lower battery unit into a live outlet and
leave it charging for 24 hours. Use only a 120v, 60Hz outlet.
2. After recharging:
Take lower battery unit out of outlet and line up prongs on
base to the opening in the handle and push together until
in place. The plug blades are polarized (one blade is wide)
and can go into the handle only one way. Push together
until there is no gap between handle and base.
IMPORTANT NOTE: The unit will not function with a
slight gap between the handle and the base. Make sure
that the base is fully pushed in.
3. Attach the brush head.
Attach and remove with just a simple twist.
4. Wet the bristles, apply a pea-size amount of toothpaste, and
put in mouth.
Clear gel or low abrasion formulations are strongly recommended to
enhance the life and performance of your brush head, but pastes may also
be used. To avoid splashing, switch the power on after placing the brush head
in your mouth.
www.interplak.com
1-800-334-4031
before carefully
this of enjoyment
Model
H S U R B H T O
Direct Plug-In Toothbrush:
®
website: our
Comments? or
book instruction
continued
Manual
•
O T N - I G U L
at us Visit
Questions
the read always
and safety your
Instruction
P T C E R I D
For