Step 12: Anti-Kickback Pawls; Step 13: Blade Guard - Delta 36-5000 T2 Series Quick Assembly Manual

Step 12: ANTI-KICKBACK PAWLS

To reduce the risk of serious personal
injury, Anti-Kickback Pawls MUST be in place when making
.
a through cut
1.
See Figure 22 and locate the Anti-Kickback Pawls Mounting
Slot in the middle of the top edge of the Riving Knife.
A
2.
Slide Slot in the middle of the Anti-Kickback Pawls
Assembly along the top of the Riving Knife until the
PC11
stem locates the center slot
B
3.
Depress the stem on the Anti-Kickback Pawls Assembly to
allow the Assembly to drop into the slot. Push down on
the Anti-Kickback Pawls Assembly until it snaps into place
and locks. Release stem. NOTE: Pull up on the Anti-
Kickback Pawls to make sure it is locked in place.
To remove the Anti-Kickback Pawls, depress the stem
the Anti-Kickback Assembly off the Riving Knife.

Step 13: BLADE GUARD

To reduce the risk of serious personal
injury, the Blade Guard MUST be in place when making a
through cut.
1.
Before installing the Blade Guard Assembly
the riving knife is raised to the through-cut position.
2.
While holding the Blade Guard Assembly in a vertical
position, hook the Locating Pin
Blade Guard Assembly into the slot at the back edge of the
Riving Knife.
3.
Rotate the Blade Guard Assembly toward the front of the
Saw until the metal portion
Assembly is parallel to the Table as shown in Figure 23.
4.
While holding down on the front of the metal portion of the
Guard press the Blade Guard Lock Lever
C
until it snaps into the locked position. Check to make sure
the Guard is locked onto the Riving Knife by pulling on the
Guard. If the Guard is not locked, the Blade Guard Lock
Lever will flip up to the unlocked position.
NOTE: Check the Blade Guard for clearances and free movement.
If the metal portion of the Blade Guard
Assembly is not parallel to the table, the Riving Knife is not
in the raised position. Remove Blade Guard Assembly and
Anti-Kickback Pawls and raise Riving Knife, then reinstall
the Anti-Kickback Pawls and
NOTE: Also reference Figure 37, page 32 of the Operator's Manual.
To Remove the Blade Guard Assembly:
1.
Lift the Blade Guard Assembly Lock Lever
unlocked position.
2. R
otate the Guard back and slide the Pin
Riving Knife Slot.
on the Riving Knife.
A
and pull
B
, make sure
PC5
at the back end of the
B
of the Blade Guard
C
down
D
the Blade Guard Assembly.
to the
D
from the
B
A
PC5
B
11
A
PC11
Figure 22
D
Figure 23
B
C