Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for BALKAN ENERGY Sofia
- Page 1 INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS...
-
Page 2: Table Of Contents
Content: General requirements ..................2 Important information ..................2 Delivery and unpacking ................... 3 Pellet stove components .................. 4 Safety requirements ..................7 User requirements .................... 7 5.1. Responsibility of the installer ................7 5.2. Installation of the pellet stove ................. 7 General requirements .................. -
Page 3: Delivery And Unpacking
Do not use water to clean the stove. Water can get inside the stove and damage the electronics. Do not open the combustion chamber door during operation of the pellet stove. Fire hazard. The user is fully responsible for the correct operation of the product, which relieves the manufacturer of responsibility for all his actions or inactions. -
Page 4: Pellet Stove Components
Pellet stove components The pellet stove consists of the following components: - combustion chamber – fig. 3; - pot - place where the pellets burn – fig. 4 and fig. 5; - water heater; - pellet hopper – pellets for burning are filled into it – fig. 1 and fig.2; - auger for pellets (screw auger)–... - Page 5 Fig.2 Fig.3...
- Page 6 Fig. 4 Burner pot Fig. 5 Burner pot...
-
Page 7: Safety Requirements
Safety Requirements 5.1 User requirements The user must: • be an adult (over 18) and responsible person; • to have certain technical knowledge necessary for the operation, maintenance and cleaning of the pellet stove. 5.2 Responsibility of the installer The installer must follow the manufacturer's requirements: •... - Page 8 It is mandatory to install a flue to remove flue gases at a height safe for human health and to be equipped with wind protection. The flue must be used only by the pellet stove and no other appliances must be connected to it.
-
Page 9: Combustion Air Supply
Fig.7 А) Mineral wool B) Steel pipes C) Barrier plate Avoid contact with combustible material (such as wooden beams) and in all cases it will be necessary to isolate them from the metal flue with fireproof materials (see figure 7). ATTENTION! Do not connect the exhaust gas system of the pellet stove to a chimney to which another stove, boiler or aspiration system is already connected. -
Page 10: Operation Of The Pellet Stove
• Do not operate the pellet stove if one of the safety devices is damaged, malfunctioning or not working. • Do not turn off the power by pulling the plug while the stove is operating. This can jeopardize the proper functioning of the pellet stove. Fig.8 7 Operation of the pellet stove 7.1 General requirements... -
Page 11: Turning On The Stove For The First Time
Clean the glass only when the stove is cold, using cotton cloth or paper towels and glass cleaner. - Make sure the ashtray is placed correctly and that the door is fully closed. - With the vacuum cleaner, remove the ash from the ash niche only when it has completely cooled down. - Page 12 Fig. 9 Fig.10...
-
Page 13: Installation
Example scheme for connecting the stove to the water-heating installation Fig. 31 Pellet boiler stove Hot water pipe Return water pipe Zone valve/fit as required / Radiators The pellet stove is equipped by the manufacturer with a water pump and expansion tank, as well as with a deaerator. -
Page 14: Pellet Quality Requirements
Pellet quality requirements ATTENTION! The pellet stove has been tested only with wood pellets with a diameter of 6 – 8 mm, class EN plus A1, acc. EN ISO 17225-2:2014. The manufacturer accepts no responsibility if you use fuel other than that recommended by the manufacturer. This pellet stove is made to use pressed wood (pellets).