Baker Hughes MASONEILAN SVI-II REMOTE MOUNT Instructions For Installing

SPECIAL INSTRUCTIONS FOR INSTALLING THE MASONEILAN
"SVI-II REMOTE MOUNT" IN AREAS WHERE THERE IS A POTENTIAL FOR EXPLOSIVE GAS ATMOSPHERE OR INFLAMMABLE DUST
I N T R O DU CT I O N
1
This manual covers the requirements for safe installation, repair, and operation of the SVI-II REMOTE MOUNT as it relates to operation in areas
where there is a potential for explosive atmosphere or inflammable dust. Adherence to these requirements assures that the SVI-II REMOTE will
not cause ignition of the surrounding atmosphere. Hazards related to control of the process are beyond the scope of this manual.
For mechanical mounting instructions on specific valves/actuators refer to the mounting instructions supplied with the corresponding mounting kit.
Mounting does not affect the suitability of the SVI-II REMOTE MOUNT for use in a potentially hazardous environment.
The SVI-II REMOTE MOUNT is manufactured by:
Dresser LLC
12970 Normandy Blvd.
Jacksonville FL – 32221 – USA
For language translation assistance, contact your local representative or e-mail valvesupport@bakerhughes.com.
Pour la langue de traduction aide, contactez votre représentant local ou envoyez un e-mail valvesupport@bakerhughes.com.
GEN ER A L R EQ U I R EM EN T S
2
!WARNING!
Failure to adhere to the requirements listed in this manual may cause loss of life
and property.
Installation and maintenance must be performed only by qualified personnel. Area Classification, Protection Type, Temperature Class, Gas Group,
and Ingress protection must conform to the data indicated on the label.
Wiring and conduit must conform to all local and national codes governing the installation. Wiring must be rated for at least 5ºC above the highest
expected ambient temperature.
Approved wire seals against ingress of water and dust are required and the NPT fittings must be sealed with tape or thread sealant in order to
meet the highest level of ingress protection.
Where the protection type depends on wiring glands, the glands must be certified for the type of protection required.
The metal housing is a die-casting alloy which is predominately aluminum.
Before powering the SVI-II REMOTE MOUNT:
Verify that the cover is fully threaded onto the housing such that the two crescent-shaped bosses are aligned and approximately in contact. Then
thread the supplied M8 socket-head cap screw securely into the threaded hole d (This ensures that the cover is not inadvertently removed). This
can be seen in the image below.
REV Description
A Initial Release
B PDR ECO-0026891
C PDR ECO-0029101
D PDR ECO-0033385
E PDR ECO-0042635
F PDR ECO-0043755
ES-787
M8 Socket-Head Cap Screw
Date
May 2014
Oct 28, 2016
May 16, 2017
May 1, 2018
Oct 29, 2020
Feb 2, 2021
Drawn P. Morley
Approved H. Smart
ES-787
Original instructions
Page 1 of 6
4APR14
4APR14
F