Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Ypsilon DAC 100
- Page 1 DAC 100 YPSILON CONVERTER OWNERS MANUAL V2 01/01/2009 ©All rights reserved...
- Page 2 INTRODUCTION Thank you for trusting YPSILON ELECTRONICS™. We assure you that you have made an excellent purchase. Your D/A Converter is made only by the best and most reliable materials and we guarantee it will offer you many hours of music enjoyment.
-
Page 3: Connecting Cables
PLACEMENT OF THE DAC 100 D/A CONVERTER DAC-100 D/A converter is designed to reduce interference from external magnetic and radio fields. Although placement is not critical, any magnetic fields should be avoided. A solid and sturdy surface should be used as this D/A converter has a substantial weight. -
Page 4: Connecting To The Mains Outlet
CONNECTING TO THE MAINS OUTLET Your D/A Converter has a description of the appropriate operation voltage on its back panel. Please make sure not to overlook the specifications. In case you need to operate it in a region with no complying voltage, contact your dealer or the factory. The power cable that you will use must be at least 3 x 1.5 square mm and grounded to the mains outlet. - Page 5 CAUTION DO NOT ATTEMPT TO OPEN THIS DEVICE. IN CASE OF ONLY USE THE VOLTAGE MALFUNCTION CONTACT YOUR DEALER OR THE PRINTED ON REAR PANEL MANUFACTURER WARNING: Before any maintenance or placement /connection takes place disconnect the device from electrical outlets. DISCONNECT THE DEVICE WARNING: Never use electrical outlets without earth Use only electrical outlets that are earthed.
-
Page 6: In Case Of Fault
Otherwise this device is out of Guarantee and will not be compliant with international rules and regulations. CONNECTING INPUT CABLES Your DAC-100 has one RCA and one YPSILON 5 PIN inputs on the back panel. Only connect signal from source. RCA INPUT... - Page 7 CONNECTING OUTPUT CABLES There are two types of output connectors on the back panel of the DAC-100.One is a RCA connector and the other an XLR connector. Only connect to pre-amplifier. RCA OUTPUT XLR OUTPUT POWER SUPPLY The DAC-100 has a power transformer manufactured in house using special winding techniques and exotic core materials for low noise and pure, transparent sound.
-
Page 8: Specifications
SPECIFICATIONS DIGITAL INPUTS SPDIF(75 ohm) RCA ANALOGUE CURRENT INPUT YPSILON 5 Pin Connector ANALOG OUTPUTS RCA unbalanced XLR unbalanced(pin1,3grounded) RESOLUTION 24 bit(multi bit converter) 192khz maximum sampling rate NOMINAL OUTPUT 2,8V rms POWER CONSUMPTION Typically 40 W DIMENSIONS 400x180x400 (WxHxD)mm...