C-RACER RH-KTM390-SB Instructions

www.c-racer.com
CONTENTS
1. 1pcs Plastic Rear Hugger
2. 1pcs Alouminio Chain Guard
3. 1pcs screws Μ6Χ15 (allen-round head-washer)
4. 1pcs screws Μ6Χ10 (allen-round head-washer)
5. 1pcs screws Μ6Χ25 (allen-round head-washer)
6. 1pcs screws Μ5Χ15 (allen-round head-washer)
7. 1pcs screws Μ5Χ55 (allen-round head-washer)
8. 1pcs washers 6Χ12
9. 1pcs plastic washers 6Χ18
10.1pcs plastic washers 5Χ15
11.1pcs safety nuts Μ6
INSTRUCTION
Model
ΚΤΜ 390/290 Adventure
Page 1/2
Product
Rear Hugger With Chain Guard
1.
4.
3.
10.
To place the new fender, you must remove the old one.
In the photos you may find the order and the place
of the screws you must remove.
First remove the cover from the front left footrest,
this helps to remove the front screw of the chain guard,
also remove the one at the back side.
After that remove the nut, (not easily seen).
(In the second photograph you will see the place of the
nut, only seen from the right side under
the shock ubsorber.)
Then remove the two main screws.
(In the third photograph there is only the right side,
on the left side there is the same screw)
After you have removed all the screws you must open
the back side of the chain guard which covers the base
on which it was mounted, to get it through from the chain.
Then rotate the fender and because it is elastic
you can carefully/easily remove it.
Code
RH-KTM390-SB / BS
2.
6.
9.
5.
8.
11.
7.