Table of Contents
Advertisement
FOUNDATION BASE
Base installation instructions
Place the TV on a flat surface. Be sure to distinguish between
the right and left of the stand and the front and rear of the
stand, then insert the stands into the slots on the bottom of
the TV according to the direction of the arrow in the figure.
Align the screw holes and make sure to screw together tightly
(Note that the base module must be adjusted as shown in the
figure, otherwise the installation will be incorrect).
Important:
The actual appearance of the base and TV may
differ from the images shown.
Please refer to the actual device.
Wall bracket installation
Warning
•
Please purchase a suitable wall mount for the TV when you
install it on the
wall.
•
Make sure the load capacity of the wall for the installation
of the wall mount is not less than 4 times the weight of the TV
and the wall mount to prevent it from
•
For more information on installing the wall mount, see the
instructions supplied with the TV and the wall
•
Make sure there are no cables or conduits in the area of the
wall where the wall bracket will be
•
If you need help with the installation of the wall mount,
contact a technician. The company is not responsible for
accidents, injuries or personal damage caused by improper
installation of the
TV.
falling.
mount.
installed.
Distance between holes in
the wall (H x V) (mm)
43":400 X 200
50": 300 X 300
65": 300 X 200
Note:
•
If you find any screws in the wall mount hole behind the TV
before you install it, remove the screws and save them for later
use.
•
Please purchase wall screws according to the actual
installation.
•
If you find silver head self-tapping screws in the
accessories, decide if they are suitable to use according to the
actual wall bracket
installation.
-
2 self-tapping flat head screws ST6x8 mm (optional).
14
Required screws (recommended screw
length) (mm)
Top: 2 x M6(8.5+L1<L<30+L1), Machine
screw.
Bottom:2xST6 (L'=6+ L1') Flat head self
tapping screws.
Top: 2 x M6{28+L1<L<30+L1), Machine
screw.
Bottom: 2 x ST6(6+ L1'<L'<9.5+ L1') Flat
head self tapping screws.
Top: 2 x M6(28+L1<L<30+L1), Machine
screw.
Bottom: 2 x ST6(6+ L1'<L'<9.5+ L1') Flat
head self tapping screws.
Hide quick links:
Advertisement
Table of Contents
