THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
: internal component.
¢
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
une marque ! sont critiques
fied by mark ! or dotted
line with mark ! are criti-
pour la sécurité.
cal for safety.
Ne les remplacer que par une
Replace only with part
piéce por tant le numéro
number specified.
spécifié.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal pro-
duction tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
g : VIDEO/MD
E
: PB (DECK A)
d
: PB (DECK B)
G
: REC (DECK B)
J
: CD
c : digital out
I : PHONO
• Abbreviation
CND : Canadian model.
AUS : Australian model.
For printed wiring boards.
Note:
• X : parts extracted from the component side.
•
: Through hole.
®
•
: internal component.
¢
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
• Indication of transistor
B
C
E
These are omitted
C
Q
These are omitted
B
E
– 35 –
HCD-DR4/DR5/DR6/DR440/W300/W5000/XB500
WAVEFORMS
– BD (CD) SECTION –
1
3.1Vp-p
16.9MHz
IC101 ^§ XTAI
2
1.2Vp-p
(PLAY)
IC101 %¡ RF AC
3
2.5V
APPROX 500mVp-p (PLAY)
IC101 $¡ TE
4
2.5V
APPROX 200m Vp-p (PLAY)
IC101 #ª FE
5
2.4Vp-p
7.5µsec
IC101 @§ MDP
– MAIN (2/5) SECTION –
1
5.5Vp-p
16MHz
IC501 !£ X-OUT
2
5.2Vp-p
32.768kHz
IC501 !¡ XC-OUT
– PANEL FL SECTION –
1
3.4Vp-p
12.5MHz
IC601 &™ X-OUT
– 36 –