JVC HR-S7965EF Instructions Manual page 57

Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Manual Channel Set" on page 55
to access the Confirmation screen before continuing.
A
Select the item.
Press rt w e until the item you want begins blinking.
B
Access the Manual Channel Set screen.
Press OK twice.
C
Select the new station.
Press e until the station
name (ID) begins blinking,
then press rt until the new
station's name (ID) you want
to store begins blinking.
Registered station names
( pg. 58) appear as you
press rt .
D
Switch the stations.
Press OK.
● The Confirmation screen appears.
● Repeat steps 1 – 4 as necessary.
E
Close the Confirmation screen.
Press MENU.
Set Stations (B)
Set station names other than the ones registered in your recorder.
Perform steps 1 and 2 of "Manual Channel Set" on page 55
to access the Confirmation screen and then perform steps 1
and 2 of "Set Stations (A)" above before continuing.
A
Select the character for station name.
Press e until the first letter of
the station name begins
blinking.
B
Enter the new character.
Press rt to cycle through the characters (A–Z, 0–9, –,
+, I (space) ) and stop when the desired character is
indicated, then press e
characters the same way (maximum of 4). After entering
all characters, press OK.
● The Confirmation screen appears.
● If you make a mistake, press
begins blinking. Then enter the correct character by pressing
rt
.
C
Close the Confirmation screen.
Press MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
f I
–, , +, (space) (maximum of 4).
Fine-Tuning Channels Already Stored
Perform steps 1 and 2 of "Manual Channel Set" on page 55
to access the Confirmation screen before continuing.
A
Select the channel to fine-tune.
Press rt w e until the channel you want to tune begins
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press e until "+/–" begins blinking, then press
the picture is its clearest. Then press OK.
● The Confirmation screen appears.
● Repeat steps 1 – 3 as necessary.
D
Close the Confirmation screen.
Press MENU.
EN
to enter. Enter the remaining
w
until the incorrect character
rt
57
f ,
until