JVC HR-S7860EK Instructions Manual page 61

DIGITAL 3R
8
ON
OFF
POWER SAVE
8
ON
OFF
VIDEO STABILIZER
8
ON
OFF
* The default setting is bold in the table below.
When this function is set to "ON", the Digital 3R picture
system applies edge correction to the luminance signal to
enhance detail.
NOTES:
● Normally it is recommended to keep "DIGITAL 3R" set to
"ON".
● Depending on the type of tape being used, picture quality may
be better with "DIGITAL 3R" set to "OFF".
● If you use the recorder as the source player for editing, be sure
to set "DIGITAL 3R" to "OFF" before starting.
When this function is set to "ON", you can reduce the
power consumption while the recorder is turned off.
NOTES:
● During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
... the picture may be distorted momentarily when you turn on/
off the recorder.
● Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder's power is turned off after timer-recording or
Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is
engaged ( pg. 37).
... "L-2 SELECT" is set to "DECODER" or "SAT" (
When this function is set to "ON", you can automatically
correct vertical vibration in the picture when playing back
unstable recordings made on another recorder.
NOTES:
● When you finish viewing a tape, be sure to set this function to
"OFF".
● Regardless of the setting, this function has no effect during
recording and during special effects playback.
● The on-screen display may jitter vertically when this function is
set to "ON".
● To watch recordings with close-caption, set this function to
"OFF".
● Video Stabilizer and Digital TBC/NR cannot be used at the same
time. If you activate Digital TBC/NR when "VIDEO STABILIZER"
is set to "ON", Video Stabilizer will be automatically turned
"OFF".
EN
pg. 70) does not work.
pg. 47).
61