NLTroubleshooting
Malfunction
Detergent or fabric softener
softer drips from
the cuff and collects on
the door or in the cuff
crease.
Centrifuge result is
not satisfied-
ity. The laundry is too
wet / too damp.
Leftover detergent
the damp laundry.
Detergent residues
the dry laundry.
Home Connect func-
doesn't dish properly.
52
Cause and Troubleshooting
Too much detergent/fabric softener in the detergent
drawer.
When dosing the liquid detergent and fabric
▶
softener, pay attention to the marking in the
detergent drawer and do not exceed it.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Launch the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
trapped.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or trapped.
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
Launch the programCentrifuge.
▶
Imbalance control system compensates for
imbalance by reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
Launch the programCentrifuge.
▶
Detergents may contain water-insoluble substances
that settle on the laundry.
Launch the programTo rinse.
▶
Detergents may contain water-insoluble substances
that settle on the laundry.
Brush the laundry after washing and drying.
▶
Various causes are possible.
Go to www.home-connect.com.
▶