Table of Contents
Advertisement
RECORDING
Zoom indicator
Downloaded from:
https://www.usersmanualguide.com/
Basic Features
Zoom-in
T
T
T
W
W
W
Zoom-out
RETAKE
Power zoom switch
START/STOP
VISS
RM-V700U (optional)
FEATURE:
Zooming
PURPOSE:
Varies the focal length of the lens and
produces the zoom in/out effect.
OPERATION:
Zoom In
T
1) Pull the power zoom switch down
W
Zoom Out
2) Push the switch up toward "W".
NOTES:
● The further the power zoom switch is
pushed, the faster the zoom speed
becomes.
● Focusing may become unstable during
zooming. In this case, set the zoom while
in Record–Standby, set manual focus or
Focus Lock (
or out in Record mode.
FEATURE:
Quick Review
PURPOSE:
To check the end of the last recording.
OPERATION:
1) Press "
NOTE:
Distortion may occur at start of playback.
This is normal.
FEATURE:
Retake
PURPOSE:
To re-record certain segments.
OPERATION:
1) Make sure the camcorder is in the
2) Press either RETAKE button to reach the
3) Press Recording Start/Stop to start
NOTE:
Noise may appear during Retake.
This is normal.
FEATURE:
Index Code Marking
PURPOSE:
To give you automatic access to any selected
point on a recording. Auto Marking and
Manual Marking are available.
OPERATION:
Auto Marking
An index code is always marked to start the
first recording on a new date after a cassette
is inserted.
Manual Marking (Using the optional
RM-V700U Remote Control Unit)
1) Press VISS once to place the index code.
NOTES:
● If VISS is pressed during
Record–Standby mode, the mark is
placed where START/STOP is pressed.
● If the date changes during a recording, it
becomes the first recording of the new
date and an index mark is placed at that
point.
15
toward "T".
pg. 20, 21), then zoom in
" for less than 2 seconds during
the Record–Standby mode.
• Tape is rewound for about 2 seconds
and played back automatically, then
pauses in Record–Standby mode for the
next shot.
Record–Standby mode.
start point for new recording.
recording.
INDEX blinks in the viewfinder during
marking.
Advertisement
Table of Contents
