ATI Technologies AT-RKMT6 Installation Manual

This manual will assist you in installation of your Rack Mount 6. When opening this Allied Telesyn product,
make sure the package you have received is complete and in good condition. This package should include:
• 2 handles (A)
• 2 trim plates (B)
• 4 flathead screws (C) (M3-8 flathead Phillips)
• 1 mounting bracket (D)
• nylon tiewraps (F)
The Rack Mount 6 will assist you in installing the following repeaters in a standard 19 inch rack.
• AT-MR820T
Installing your Allied Telesyn Rack Mount 6 is simple and quick (only requiring a Phillips screwdriver), as
seen in Figure 1 below:
Repeater
A
1. Attach handle A to trim plate B and bracket D with flathead screws C.
2. Remove the four rubber feet (not shown in Figure) from the bottom of the repeater, and reinstall the
screws.
3. Attach bracket assembly to device (see list above) with flathead screws E.
4. Attach the single unit in a standard 19 inch rack.
5. Secure cables with tie wrap(s) F.
PN 613-10565-00 Rev. A
• AT-MR420T
C
B
Figure 1: Installation
AT-RKMT6 Installation Manual
D
E
F
C
E