Table of Contents
Advertisement
Things You Should Know
6-F Before Requesting Help
Problem
•Check the settings (1-C).
The unit does not work.
•Charge the battery fully (6-A).
•Clean the charge contacts and charge
•Install the battery properly (6-B).
•Place the handset on the base unit and
•Re-install the battery and place the
•You are too far from the base unit. Move
An alarm tone sounds.
•Place the handset on the base unit and try
•Plug in the AC adaptor.
•Raise the base unit antennas.
•Locate the handset and the base unit
Static, sound cuts in/out,
fades. Interference from
other electrical units.
•Move closer to the base unit.
•Raise the base unit antennas.
•Press
•The ringer volume is set to OFF. Press
The unit does not ring.
•To answer the call, press
While storing a phone
number, the unit starts to
ring.
•You cannot store a number while the unit
You cannot store a
phone number in
•Do not pause for over 60 seconds while
memory.
•If a power failure occurs, programmed
Previously programmed
information is erased.
•If the last number dialed was more than
You cannot redial by
pressing
.
(REDIAL)
•The handset is too far from the base unit
does
(HANDSET!LOCATOR)
not function.
•Charge the battery fully (6-A).
The RECHARGE
indicator flashes or the
unit beeps intermittently.
•Clean the charge contacts and charge
You charged the battery
fully, but the RECHARGE
•Install a new battery (6-B).
indicator flashes.
•This is normal.
The IN USE/CHARGE
indicator light does not
go out while charging.
•Call our customer call center at
If you cannot solve your
problem.
•Panasonic's e-mail address for customer
Remedy
again (6-A).
unplug the AC adaptor to reset. Plug in,
and try again.
handset on the base unit. Try again.
closer and try again.
again.
away from other electrical appliances
(6-D).
to select a clearer channel.
(CH)
or
while the TALK indicator light is off
Ö
(2-B).
(TALK)
program will be canceled. Store the
number again.
is in the talk mode.
storing.
information may be erased. Reprogram if
necessary.
32 digits long, the number will not be
redialed correctly.
or is engaged in an outside call.
again (6-A).
1-800-211-PANA(7262).
inquiries:
consumerproducts@panasonic.com
for customers in the USA or Puerto Rico
ONLY
6-G Helpful Information
Operating near 2.4GHz electrical appliances may cause interference. Move
away from the electrical appliances and/or press the CH (Channel) button.
The AC adaptor is used as the main disconnect device, ensure that the AC
outlet is located/installed near the unit and is easily accessible.
• Environment— do not place the unit in a room where the temperature is
less than 5°C (41°F) or greater than 40°C (104°F). Allow 10 cm (4")
clearance around the unit for proper ventilation. Avoid excessive smoke,
dust, mechanical vibration, shock, or direct sunlight.
• Medical—consult the manufacturer of any personal medical devices,
such as pacemakers, to determine if they are adequately shielded from
external RF (radio frequency) energy. (The unit operates in the
frequency range of 2401MHz to 2472MHz, and the power output level
can range from 0.001 watts to 0.20 watts.) Do not use the unit in health
care facilities if any regulations posted in the area instruct you not to do
so. Hospitals or health care facilities may be using equipment that could
be sensitive to external RF (radio frequency) energy.
• Routine care—wipe the unit with a soft cloth. Do not use benzine,
thinner, or any abrasive powder. When you leave the unit unused for a
long period of time, unplug the AC adaptor from the outlet.
• If there is any trouble— disconnect the unit from the telephone line
and connect a known working phone. If the known working phone
operates properly, have your unit repaired by one of the authorized
Panasonic Factory Service Centers. If the known working phone does
not operate properly, consult your telephone company.
Caution:
Ñ
To comply with FCC RF exposure requirements, the base unit should be
installed with its antenna located at 20 cm or more from persons and
handset should be carried with the specific belt-clip provided for the
handset to ensure compliance. Other non-tested belt-clips or similar body-
. The
worn accessories may not comply, therefore, should be avoided.
Shock-Resistant (HANDSET ONLY)
Although the handset is designed to be shock resistant, do not throw or
step on the handset.
Splash-Resistant (HANDSET ONLY)
The handset is designed to be splash resistant.
You can use the handset with wet hands.
CAUTION:
• Do not immerse in water or leave under running water.
• Keep the handset away from salt water.
• Avoid exposure to prolonged high humidity.
• Since water in headset jack may cause damage, close the headset jack
cover when the optional headset is not in use. When the optional headset
is connected, do not use the handset with wet hands.
• If the handset is wet, wipe with a soft dry cloth.
• The base unit is not designed to be splash resistant. Do not place the wet
handset on the base unit.
Section 6
Advertisement
Table of Contents
