Wireless Remote Control - LG LW1823HR Owner's Manual

Wi-Fi (Wi-Fi Model Only)
5
Enables connection of the air conditioner to
the home Wi-Fi.
NOTE
• Follow instructions on LG ThinQ
application on how to connect to your
unit.
Filter Reset
6
The Clean Filter LED lights up to notify you
that the filter needs to be cleaned. After
cleaning the filter, press Filter Reset on
the control panel to turn off the Clean Filter
light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the
air filter for more efficient operation.
The LED light turns on after 250 hours
of operation.
Temperature Control
7
The thermostat monitors room
temperature to maintain the desired
temperature. The thermostat can be set
between 60 °F–86 °F (16 °C–30 °C).
Press or
decrease temperature setting.
Auto Swing
8
The horizontal air flow can be adjusted by
pressing the Auto Swing button. Press
this button once, the vertical louver will
swing left and right automatically. To stop
the louver at a desired angle, press Auto
Swing button again.
NOTE
• A slight heat odor may come from the unit
when first switching to HEAT after the cooling
season is over. This odor, caused by fine dust
particles on the heater, will dissipate quickly.
• Auto Restart : If the air conditioner turns
off due to a power outage, it will restart
automatically once the power is restored, with
the same settings as were set before the unit
turned off.
arrows to increase or
• Energy Saver : The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
• The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.

Wireless Remote Control

Inserting Batteries
1
Push out the cover on the back of the remote
control with your thumb.
2
With the plus and minus poles facing as
marked, and insert two new AAA 1.5 V
batteries.
3
Reattach the cover.
NOTE
• Two new batteries are supplied with the air
conditioner for use in the remote control.
• Do not use a rechargeable battery. Make sure
that the battery is new.
• In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
• Keep the remote control away from extremely
hot or humid places.
• To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
EN
17