PARK WAREHOUSE 685se605 Installation

Match Poi nt Aluminum Volleyball System
P A R T S L I S T
Item Qty
A 2
B 1
C 1
D 2
♦
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦
Read all instructions before proceeding.
♦
These systems will adjust from 7'11-5/8" men's net height to 42" tennis height.
1. If applicable, follow the instructions provided with the Floor Sockets (F) to prepare the court for system
installation, use the diagram on page 3 to locate the Floor Sockets (F) on your court.
2. Place the VB60S Volleyball Standards (A) in the Floor Sockets (F) with the Slider Bars (B) and (C) toward
the inside of the court.
3. Uncoil approximately 24" of the web strap from the winch to allow for net tensioning.
4. Attach the kevlar top rope to the Slider Bars (B) and (C). On the Net Tensioning Slider Bar (B), the rope
will loop over the pulley and attach to the spring clip on the end of the winch strap. On the Non-Tensioning
Slider Bar (C) attach the loop to the hook on the top of the Non-Tensioning Slider Bar (C). See Figure 1.
5. Tension the top rope by tightening the net top tension crank. See Figure 1.
6. Attach the loop on one end of the bottom rope to the hook on the bottom of the slider bar. Attach the other
end of the bottom rope with the spring hook on the rope ratchet. Tension the bottom rope by pulling the
rope through the bottom Rope Ratchet Tensioner (E). See Figure 1.
7. Loop two small Rope Ratchet Tensioners (E) around each standard and through the eyelets on the net side
tapes. Tension the net sides by pulling the end of the ropes. Release the Rope Ratchet Tensioners (E) by
pressing on the release button. Rope Ratchet Tensioners (E) should be rotated close to the pole and behind
the padding to prevent contact with players. See Figure 1.
8. Once the VB1250K Net (G) is attached it must be adjusted to its desired height. Loosen the winch to
release the net tension. Do this before moving the Slider Bars (B) and (C). See Figure 1.
SKU: 685se
Description
VB60S Volleyball Standards
Net Tensioning Slider Bar Assembly
Non-Tensioning Slider Bar Assembly
Height Labels
60 Installation 5
Item Qty Description
E 4 Rope Ratchet Tensioners (Packaged w/ Net)
F 2 Floor Sockets (if applicable)
G 1 VB1250K Net
1