Advertisement
KEMKRAFT
* INSTALLATION INSTRUCTIONS *
1. The KEI-325B Display box should be permanently installed in a location that is best for the
application. It is usually mounted straight out the drivers side window on a pedestal stand.
2. When the box is installed, place a vehicle in the alignment machine and install the
mechanical fixture onto the steering wheel. Ensure that the KEI-325B display box can be
easily viewed while loading an Unfixtured Clear Vision Tool onto a steering wheel.
* OPERATING INSTRUCTIONS *
NOTE: As always, these Steering Wheel Gauges are delicate, accurate, gauging tools
that need to be treated as such and therefore must be installed in a holder when
not in use. If these tools do not have a holder & are thrown down on a table
during use, the warranty will be void.
1. Apply power to the KEI-325B by turning on the power switch located on the bottom left part
of the enclosure. This power switch also doubles as a circuit breaker for the KEI-325B
Display box. Should the breaker ever trip the power switch only needs to be turned to the
off position and back on to reset the breaker.
2. After the power has been applied to the KEI-325B Display box the LCD display will have
this display.
4. If power is applied and the KEI-325B Display box has the LCD has the following display,
the calibration data is bad and the unit needs to be calibrated.
5. The KEI-325B has 3 LED's on the front of the Display box. These are Limit indicators of the
steering wheel guage.
6. Factory setings for these limits:
LO: -10.00 Degrees
HI: +10.00 Degrees
7. The KEI-325B also has an audible sonalert that sounds if the steering wheel gauge is
below -10.00 Deg or above +10.00 Deg.
96-027.doc
47650 Clipper Dr. Plymouth Twp., MICHIGAN 48170 (734)-414-6500
MODEL KEI-325B READOUT BOX
XX.XX Deg TL#1
CAL SW = Calibrate
MEMORY ERROR
CALIBRT TOOL NOW
2
ENGINEERING, INC.
Advertisement
