Table of Contents
Advertisement
• The indicators
and
• The indicator
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A where level 0A
means no rinse aid is used.
3. Press Delay repeatedly to change
the setting.
4. Press on/off to confirm the setting.
6.4 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If the drying results are
satisfactory while using multi-tablets
only, it is possible to deactivate the
notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
,
and
flashing and the display is blank.
2. Press Start.
• The indicators
is off.
• The indicator
flashes.
• The display shows the current
setting:
= the rinse aid empty
,
are off.
still flashes.
= level 4.
,
start
,
and
still
notification is activated (factory
setting).
3. Press Start to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press on/off to confirm the setting.
6.5 AirDry
AirDry improves the drying results with
less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
CAUTION!
In case of presence of
children, the AirDry system
can be deactivated if you
want to keep the door
closed in the end of the
cycle.
To improve the drying performance refer
to the XtraDry option or activate AirDry.
How to deactivate AirDry
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
ENGLISH
11
,
Advertisement
Table of Contents
