KOEHOG K832 Instruction Manual

INSTRUCTION MANUAL
menu
KOEHOG K832 Video Baby Monitor
with 4.3'' LCD Screen and Two Cameras
Please read the following instructions and warnings carefully
Tools required for wall mount: Screwdriver and drill (not included)
Keep this instruction manual for future VFor technical support see FAQ page.
For adult use only.
FEATURES & COMPONENTS
Camera:
Monitor:
*LED
Power & Low Battery Sound Lights
× 1
Revised at 8/2020
VOX
Get to know us at: www.koehog.com
1. Power Indicator
2. Lens
3. Nighttime LEDs
4. Microphone
5. Temperature Sensor
6. Power On / Off Switch
7. Speaker
8. DC Jack
1. LED*
2. Power / Menu
3. Talk Back
4. Volume Up
5. Volume Down
6. To Select a Camera / Up
7. Auto-scan / Down
8. Zoom / Left
9. VOX / Right
10. Microphone
11. Speaker
12. Battery Compartment
13. Kickstand
14. Video On / Off
15. DC Jack
Adapter:
× 3 × 2
WARNING
THIS PRODUCT CAN NOT SUBSTITUE PARENT'S SUPERVISION ON YOUR CHILD.
Model- K832
- Store this product out of the reach of babies (at least 1 meter away from the crib). A strap wound
around baby's neck may result in asphyxiation. Use safety clip to clamp the power cord and keep it
out of baby's reach. Do not use other extension cords. Only use the AC adapter provided.
- Do not touch the exposed part if the adapter is connected with power.
- Test regularly before initial use or when change the position of camera.
- Avoid placing the product in humid place or contacting with liquid. (such as bathtub, sink, etc.)
- Do not apply heat to the product.(such as stoves, radiators, etc.)
- Using the product in ventilated place. Avoid placing it on sofas, cushions, beds or other places which
may block ventilation.
- The product only can be operated by adult. Do not allow baby to play with it. Tiny accessories are
contained, please be careful when unpack and install it.
BATTERY WARNING
- Only use the recommended rechargeable battery. Please contact with us if you need to change it. For
contact list, please refer to the last page of the instruction.
- Please clean the battery container before using.
- Avoid short circuit at power supply terminal.
- Remove the battery when you are not using it or when running out of power.
- Keep battery away from children.
- Dispose the empty battery properly.
WARNING
Asphyxiation Danger:
crib). A strap wound around baby's neck may result in asphyxiation. Use safety clip to clamp the power
cord and keep it out of baby's reach. Do not use other extension cords. Only use the AC adapter provided.
SETUP & USE
Please charge the battery for at least 8 hours
before using the product.
Step 1: Test reception first, put camera in a suitable
place that will provide you the best view of your baby in
the crib (Note: Do not hang up the camera firmly until
initial installation test is completed). Plug adapter into
wall outlet and turn on the camera.
Step 2: Turn on monitor by pressing and holding Power /
Menu button for 5 seconds until "KOEHOG" shows
up, then video will show up on the screen immediately.
If video does not show up, please refer to "TO PAIR
MONITOR AND CAMERA (ADD CAMERA)" at next page. If
video shows up, the initial installation test is completed,
then you can set up the camera according to the
instruction below.
Set Up Camera: Place camera on a flat surface, such as
wardrobe or shelf (Figure 1). Or hang it on the wall
(Figure 2). No matter wherever to place the camera,
please make sure to keep it away from the crib for at least
3 feet and all power cords should be placed behind the
camera properly. Then adjust the angle of camera lens
until the entire crib shows up on the display, or adjust it
to the best angle that you think to watch your baby.
TO USE PLUGGED-IN MODE
Step 1: Place the monitor display in living room, bedroom or any place you want to watch your baby.
Use adapter to connect camera with electrical outlet.
Step 2: Turn on monitor by pressing POWER/MENU
video shows up on the screen.
Step 3: Press VIDEO ON/OFF
Step 4: Turn off the monitor completely by pressing and holding POWER/MENU
5 seconds.
TO USE PORTABLE / BATTERY MODE
Please charge the battery for 6 ~ 8 hours before using the product.
Step 1: Charge the battery for at least 8 hours before using portable / battery mode.
Step 2: Make sure the adapter is plugged into camera.
Step 3: The battery life can be up to 16 hours if it is fully charged.
Battery life will be shortened if recharging it continuously. Unplug the AC adapter when you are not
using it for a long time.
TO PAIR MONITOR AND CAMERA (ADD CAMERA)
The monitor and camera are paired before shipment. If it is unpaired for some reason, please refer
to the following steps:
Step 1: Make sure the camera and monitor are in the same space.
Step 2:
Step 3:
menu
Store this product out of the reach of babies (at least 3 feet away from the
button for 5 seconds until KOEHOG logo or
button to turn off the video if you only need to hear the voice.
Make sure the AC adapter is plugged into
camera and turn on the camera by
pressing Power On/Off Switch "
button for 5 seconds.
No
menu
Signal
VOX VOX
Figure 1
3 feet
3 feet
Figure 2
button for
"
Turn on monitor by pressing
and holding POWER/MENU
button for 5 seconds.