Table of Contents
Advertisement
Fault
"AIr" and the appli-
ance is not respond-
ing to operation.
Water is leaking from
the appliance.
Water overflows when
filling the water tank.
The laundry is too
damp.
Cause and troubleshooting
The ambient temperature is low and the base unit fil-
ter is damp.
→ "Cleaning the filter system on the base unit",
1.
Page 29.
Dry the filter thoroughly after cleaning.
2.
→ "Closing the base unit", Page 45.
3.
→ "Switching off the appliance", Page 29.
4.
→ "Switching on the appliance", Page 28.
5.
→ "Starting the programme", Page 29.
6.
Automatic self-cleaning function rinses the appliance's
heat exchanger.
Not a fault.
1.
Do not pull out the condensation tank.
2.
Do not cancel the programme.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The seal for the heat exchanger cover is dirty.
Clean the seal for the heat exchanger cover.
▶
→ "Cleaning the filter system on the base unit",
Page 29
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The lever for the heat exchanger cover is not closed
correctly.
Ensure that the lever for the heat exchanger cover
▶
is closed correctly.
→ "Closing the base unit", Page 45
The water tank for the crease-removal function is
empty.
→ "Filling the water tank", Page 33.
▶
The water tank has been filled.
Note: The overflowing water is harmless.
Do not pour any more water into the water tank.
▶
The water tank filter is soiled.
→ "Cleaning the water tank filter", Page 46.
▶
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 24
Troubleshooting en
53
Advertisement
Table of Contents
