On occasion, after printing of our literature is completed, our manufacturers may make changes and/or modifications to merchandise which will not be reflected in this manual. Although
we strive to maintain complete and accurate information, it is possible in some instances, that the product may differ slightly from printed specifications. Illustrations are intended for
reference only. Actual merchandise may vary. Wilmar is not responsible for typographical errors.
OWNERS MANUAL
Please read these instructions carefully and retain them for future use.
Page 1
H.V.L.P. GRAVITY FEED SPRAY GUN Stock Number M707 OWNERS MANUAL Please read these instructions carefully and retain them for future use. On occasion, after printing of our literature is completed, our manufacturers may make changes and/or modifications to merchandise which will not be reflected in this manual. Although we strive to maintain complete and accurate information, it is possible in some instances, that the product may differ slightly from printed specifications.
SPECIFICATIONS Air Pressure: ........15 - 45 P.S.I. Avg. Air Consumption (CFM): ....... 7-9 Spray pattern: ........... 3-7 in. Fluid Inlet (NPS): ........3/8 in. Spray Head & Needle: ....1.3, 1.5 & 1.7 MM Air Inlet (NPS): ........... 1/4 in. Cup capacity: ......... 1000 ml Hose Size (ID): ...........
CARE & MAINTENANCE Warning! Clean gun before and after each use. To protect the precision machined internal parts and fit- cup filter. Replace if worn. tings in this gun from corrosion during shipping, some oils A clean air source is imperative to ensure peak perfor- or other corrosion resistant agents may have been applied.
REPLACEMENT PARTS LIST REPLACEMENT PARTS LIST Description Qty. Description Qty. Air Adjustment Valve (6.5 x 1.9 mm) Air Cap Locking Ring Gasket Air Cap Washer Air Valve Spring Air Cap Air Valve Piston Shaft Fluid Nozzle O-Ring (10.5 x 5.2 x 2.5 mm) Air Manifold Air Valve Seat Tapered Washer (34.5 x 32.5 x 1.6 mm)
REPLACEMENT PARTS LIST Description Qty. Description Qty. Locking Spring Fluid Needle Gasket (9 x 3.3 x 2 mm) Fluid Needle Spring Trigger Pin - Pivot Fluid Adjustment Locking Ring Trigger Pin - Fluid Needle Fluid Adjustment Knob Trigger Pattern Adjustment Valve Retaining Ring (10 x 1.5, 9 x 1.9 mm) Air Inlet Fitting...
Page 6
LIMITED WARRANTY PERFORMANCE TOOL® extends only the following warranties, and only to original retail purchasers. These warranties give specific legal rights. Except where prohibited by local law, the law of the State of Washington governs all warranties and all exclusions and limitations of warranties and remedies. There may be other rights which vary from state to state.