Panasonic PT-52DL10 Hardware Replacement Manual page 3

Replacing the lamp unit
Remove Procedure
1 Remove the speaker grille.
Speaker grille
2 Remove the lamp unit cover, loosening the screw
fixing it. The screw is located on the left bottom.
Do not touch these screws.
Lamp unit cover
Lamp unit
Tabs
3 Loosen the two screws securing the lamp unit. Check
that the lamp unit and its region are completely cool.
The two screws are located on the right top and left
bottom.
Warning:
•
Because the temperature of the lamp unit is
elevated immediately after its use, a direct touch
to it may cause burns.
4 Pull out the lamp unit slowly.
Install Procedure
1 Install a new lamp unit slowly.
2 After fully inserting the lamp unit, tighten the two
screws located on the right top and left bottom.
Replacing the lamp unit
3 Insert the Tabs into the main unit as shown.
Lamp unit
Tabs
After fully inserting the lamp unit panel, tighten the
screw located on the left bottom.
Do not touch these screws.
Lamp unit cover
4 Firmly install the speaker grille.
Speaker grille